Colzer PD223A Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Luftentfeuchter Colzer PD223A herunter. Colzer PD223A 20 Seiten.

Uncoil the power cord and plug it firmly into a properly grounded 110-120 volt AC outlet.

After plugged in, the control panel will be light up for 1-2 seconds and then goes off, which is the

normal self-diagnose process and does not require any user intervention.

3. Turn the Dehumidifier On

Press the POWER button to turn the dehumidifier on. Typically, the dehumidifier will run in the

default setting of 30% set humidity at low fan speed in the normal DEHUMIDIFY mode.

NOTE: If the dehumidifier does not run automatically and you see the "FULL" icon illuminate, please

remove the water bucket and re-install it properly.

In the DH (DEHUMIDIFY) mode, the dehumidifier will automatically stop and restart based on the

humidity setting, which is called Humidstat Mode, hence maintaining the room humidity within the

range of ±3% of the set point.

For example, the set humidity is 50%, the dehumidifier will automatically stop working when the

room humidity reaches 47%, and then automatically restart when the room humidity raises up to

53%.

NOTE:

When the set humidity level is not at least 3% lower than the room humidity level, the dehumidifier

won't start, and DH icon will flash.

When the room humidity level has been dropped down to the set-point, the dehumidifier will auto

stop dehumidifying and the DH icon will flash.

If you set the target humidity at 30%, the dehumidifier will run continuously until the water bucket

is full, which is called CONTINUOUS Mode.

To run the dehumidifier in the normal DEHUMIDIFY mode:

· Select Mode: Press the MODE button until you see the "DH" icon light up on the display to select

the normal DEHUMIDIFY mode.

· Check the Room Humidity: when no operation on the control panel, the digital number on the

display is the humidity readout of the inlet air, which is similar to the room humidity level.

· Set Your Desired Humidity: After selecting DEHUMIDIFY mode, press the HUMIDITY button

repeatedly to adjust the set-point of humidity level between 30%-80% in 5% increments. The digital

number will flash when changes are being made. The set humidity needs to be at least 5% lower

than the room humidity. After you have selected the desired value, please wait for 5 seconds until