Colzer YC-100A Gebrauchsanweisung - Seite 16
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Küchengeräte Colzer YC-100A herunter. Colzer YC-100A 16 Seiten. Built-in wine cooler
Seite drucken
PROBLEM
The light does not
work.
Vibrations.
The cooler seems to
make too much
noise.
The door will not
close properly.
Moisture build up on
interior or
exterior of the wine
cooler.
Error Code:
E1-E2-E3-E4-E7-E8
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped
or a blown fuse.
The light button is "OFF".
The cooler is not leveled.
The bottles are vibrating.
There is an object under the
cooler.
The cooler is not level.
Normal noise from the flow
of the refrigerant
The cooler is not level.
The door was reversed and
not properly installed.
The gasket is dirty.
The shelves are out of
position.
This is normal during high
humidity periods.
This is normal in high
temperature environment.
Prolonged or frequent door
openings.
The door does not seal
completely.
A sensor has failed.
SOLUTION
Plug the cooler in.
Check the breaker and/or fuses.
Press
to turn the light ON.
Check to assure that the cooler is level.
Make sure the bottles don't touch each
others.
Remove the object under the cooler.
Level the cooler.
The rattling noise may come from the flow
of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your
cooler. Contraction and expansion of the
inside walls may cause popping and
crackling noises.
Level the cooler.
Re-install the door properly.
Clean the door gasket.
Place the shelves properly.
Lower the room humidity.
Move the cooler to a cooler place, and avoid
heat and sunlight.
Open the door less often.
Check door gaskets for proper seal.
Contact the customer service at