Asus AAM6020BI-T4 Benutzerhandbuch - Seite 21

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Netzwerk-Router Asus AAM6020BI-T4 herunter. Asus AAM6020BI-T4 38 Seiten. Cpe (customer premises equipment) adsl 4 port router

Seite drucken

By turning off the DHCP server and relay the network administrator must carefully configure the IP

address, Subnet Mask and DNS settings of every computer on your network. Do not assign the same IP

address to more than one computer and your CPE must be on the same subnet as all the other computers.

The apply button will temporarily save this connection. To make the change permanent you need to click

on Tools (at the top of the page) and select System Commands. At the system commands page, click on

Save All.

4.5.2

Changing the CPEs IP address

You can change the CPE's IP address by going to the Home screen, click setup and under LAN Setup,

select Management. This will bring up the screen shown in Figure 11.

Static IP address assignment

4.5.2.1

Your CPE's default IP address and subnet mask are 192.168.1.1/255.255.255.0; this subnet mask will allow

the CPE to support 254 users. If you want to support a larger number of users you can change the subnet

mask; but remember. The DHCP server is defaulted to only give out 255 IP addresses. Further remember

that if you change your CPEs' IP address and you have DHCP enabled, the DHCP configuration must

reside within the same subnet

The default CPE is the routing device used to forward all traffic that is not addressed to a station within the

local subnet. Your ISP will provide you with the default CPE Address. Figure 11 shows a default CPE

address of 192.168.1.1 because this was the default CPE defined when the CLIP connection was configured.

The hostname can be any alphanumeric word that does not contain spaces. The domain name is used to in

conjunction with the host name to uniquely identify the CPE. To access the CPE's web pages the user can

type 192.168.1.1 (the CPE's default IP address) or type mygateway.

Figure 10 (Example of a DHCP Relay configuration)

AAM6030BI User Manual