Douglas Dynamics Fisher Minute Mount 2 XLS 50810 Installationsanleitung Handbuch - Seite 14

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Zubehör für Kraftfahrzeuge Douglas Dynamics Fisher Minute Mount 2 XLS 50810 herunter. Douglas Dynamics Fisher Minute Mount 2 XLS 50810 17 Seiten. Snowplow

Seite drucken

50600, 50810

VEHICLE LIGHTING CHECK

1. Verify the operation of all vehicle front lighting

prior to connecting the snowplow harness.

2. Check the operation of the snowplow lights with

snowplow mounted to vehicle and all harnesses

connected.

Turn signals and parking lamps

Parking lamps ON:

• Both vehicle and snowplow parking lamps

should be ON at the same time.

Driver-side turn signal ON:

• Both vehicle and snowplow driver-side turn

signal lamps should ﬂ ash at the same time.

Passenger-side turn signal ON:

• Both vehicle and snowplow passenger-side

turn signal lamps should ﬂ ash at the same time.

Headlamps

Move vehicle headlamp switch to the

"ON" position. Connecting and disconnecting the

snowplow lighting harness plug should switch the

lights between vehicle and snowplow as follows:

Snowplow lighting harness DISCONNECTED:

• Vehicle headlamps should be ON.

• Snowplow headlamps should be OFF.

Snowplow lighting harness CONNECTED:

• Snowplow headlamps should be ON.

• Vehicle headlamps should be OFF.

Dimmer switch should toggle headlamps between

high and low beams. The high beam indicator on

the dash should light when headlamps are placed

in high beam.

Daytime Running Lamps (DRLs)

An operational check of the vehicle and snowplow

DRLs will depend on the vehicle model, vehicle

DRL system and type of Isolation Module

installed. Due to the variations in the OEM DRL

systems and the different Isolation Module

Lit. No. 50579, Rev. 02

options available, checking the functionality of the

snowplow DRLs will depend on the type of module

installed on the vehicle.

With headlamp switch OFF, activate the vehicle

DRLs.

Snowplow lighting harness DISCONNECTED:

• Vehicle DRLs should be ON.

• Snowplow headlamps should be OFF.

Snowplow lighting harness CONNECTED and

vehicle in DRL mode:

• Check snowplow DRL function per the type of

Isolation Module installed.

Refer to the Mechanic's Guide for information on

the Isolation Module DRL functions.

Hand-Held Control

The snowplow plugs do need to be connected to

the vehicle harness connectors. The control power

indicator light should light whenever the control

ON/OFF switch and the ignition (key) switches are

both in the "ON" position.

3. Connect all snowplow and vehicle harnesses.

Raise the snowplow and aim snowplow

headlamps according to the Snowplow Headlamp

Beam Aiming instructions included with the

headlamps and any state or local regulations.

4. Check aim of vehicle headlamps with snowplow

removed.

On 2-plug electrical systems, plug covers shall

be used whenever snowplow is disconnected.

Vehicle Battery Cable is 12-volt unfused source.

5. When the snowplow is removed from the vehicle,

install plug covers on the vehicle battery cable

and lighting harness. Insert the snowplow battery

cable and lighting harness into the cable boot on

the snowplow.

CAUTION

April 15, 2010