Doulton Ceramic Twin Undersink Installations- und Wartungshandbuch
Blättern Sie online oder laden Sie pdf Installations- und Wartungshandbuch für Water Filtration Systems Doulton Ceramic Twin Undersink herunter. Doulton Ceramic Twin Undersink 2 Seiten.
Seite druckenPLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLATION
CONGRATULATIONS on your purchase of the Doulton Ceramic Twin Undersink system.
With proper installation and maintenance of this unit you will enjoy many years of reliable service, providing you
and your family with genuine sub-micron, premium filtered water.
Step by Step Installation
Diagram 1 - Undersink Setup
7
A
4
5
2
see
Diagram 2
1
Installing your undersink system - Taking into consideration ease of maintenance, find a convenient location
beneath the benchtop. Using the selftapping screws provided, attach the filter to the cupboard wall (allowing approx
50mm height for servicing). The system may otherwise stand freely on the cupboard floor.
2
Shut Off the Water Supply - Locate the water ministop valve (see
the hot and cold water pipes, turn on the hot water at the faucet. After the water is warm to the touch, feel the pipes
under the sink).
Close the cold water ministop valve. Turn on the cold water at the
faucet to assure that the line is completely shut off and drained. (If
there is no cold water ministop valve located under the sink, it is
necessary to turn off the main water supply at the entry to the house).
WARNING: This unit must be installed on the COLD water line.
3
Attach Swivel Compression Tee (see
hose from ministop valve. Screw in the swivel compression tee.
Reattach braided hose.
Connect the System - To make a connection, the tube is simply
4
pushed in by hand. Please refer to
tubing long, do not cut to an exact length. Ensure cut is straight and
square with a clean surface.
Doulton Ceramic Twin Undersink
Installation & Maintenance Guide
1/4"
A
1
1/4"
B
faucet.
Included Parts
6
Chrome Faucet
1
Housing
2
B
Stainless Steel Bracket
3
3
Tee Piece
4
PLV
5
Blue Tube
6
Screws
7
Red Clips
Diagram
3. Where possible, leave
Diagram
blue tube
connects the feed water valve to the Pre-Filter.
blue tube
connects the Carbon Block Post Filter to the chrome
Diagram
2) - Unscrew braided
For more information go to www.watershop.com.au
Specifications
Filter Output
5000 litres
Max Flow Rate
3 litres p/min
Dimensions (cm) 23(W) x 32(H) x 13(D)
Warranty
5 years*
*Warranty Terms & Conditions apply. For more information
go to www.watershop.com.au.
0.2
Micron Nominal
Micron Rating
3) for the cold water feed line. (To identify
Diagram 2
1/2" Braided Hose (to
mixer/kitchen faucet)
1/2" Swivel
Compression Tee
Cold Water
Instructions
Quick Fit Connector
for 1/4" Blue Tube
Feed Water
Shut-off Valve
Ministop
Valve