Asus AP100 Hardware-Referenzhandbuch - Seite 32

Blättern Sie online oder laden Sie pdf Hardware-Referenzhandbuch für Server Asus AP100 herunter. Asus AP100 32 Seiten. Pentium ii startup server

Seite drucken

IV. Appendix

Glossary

Byte (Binary Term)

One byte is a group of eight contiguous bits. A byte is used to represent a single alphanumeric

character, punctuation mark, or other symbol.

COM Port

COM is a logical device name used by to designate the computer serial ports. Pointing devices,

modems, and infrared modules can be connected to COM ports. Each COM port is configured

to use a different IRQ and address assignment.

CPU (Central Processing Unit)

The CPU, sometimes called "Processor," actually functions as the "brain" of the computer. It

interprets and executes program commands and processes all the data stored in memory. Cur-

rently, there are socket 7, slot 1, and slot 2 CPUs. Intel Pentium Processors fit on socket 7, Intel

Pentium II fit on slot 1, and Intel Xeon fit on slot 2.

IDE (Integrated Drive Electronics)

IDE devices integrate the drive control circuitry directly on the drive itself, eliminating the

need for a separate adapter card (in the case for SCSI devices). UltraDMA/33 IDE devices can

achieve up to 33MB/Sec transfer.

LPT Port (Line Printer Port)

Logical device name reserved by DOS for the computer parallel ports. Each LPT port is con-

figured to use a different IRQ and address assignment.

PCI Bus (Peripheral Component Interconnect Local Bus)

PCI bus is a specification that defines a 32-bit data bus interface. PCI is a standard widely used

by expansion card manufacturers.

Peripherals

Peripherals are devices attached to the computer via I/O ports. Peripheral devices allow your

computer to perform an almost limitless variety of specialized tasks.

POST (Power On Self Test)

When you turn on the computer, it will first run through the POST, a series of software-controlled

diagnostic tests. The POST checks system memory, the motherboard circuitry, the display, the

keyboard, the diskette drive, and other I/O devices.

PS/2 Port

PS/2 ports are based on IBM Micro Channel Architecture. This type of architecture transfers

data through a 16-bit or 32-bit bus. A PS/2 mouse and/or keyboard may be used on ATX

motherboards.

RAID (Redundant Array of Inexpensive Disks)

RAID can be set up to provide mirroring (for fault tolerance), parity (for data guarding), or

striping (for data distribution over several drives for increased performance). A RAID card is

required to setup a RAID system.

RAM (Random Access Memory)

There are several different types of RAM such as DRAM (Dynamic RAM), EDO DRAM (Ex-

tended Data Out DRAM), SDRAM (Synchronous DRAM).

ROM (Read Only Memory)

ROM is nonvolatile memory used to store permanent programs (called firmware) used in cer-

tain computer components. Flash ROM (or EEPROM) can be reprogrammed with new pro-

grams (or BIOS).

SCSI (Small Computer System Interface)

High speed parallel interface defined by the X3T9.2 committee of the American National Stan-

dards Institute (ANSI) for connecting many peripheral devices.

AP100 Hardware Reference Guide