Asus AP5000 Installationshandbuch - Seite 13
Blättern Sie online oder laden Sie pdf Installationshandbuch für Server Asus AP5000 herunter. Asus AP5000 32 Seiten. Dual pentium ii server platform
Seite drucken
II. BARE-BONE KITS
Items
Golden Finger
Power Cable
SCSI connector
SCSI_ID (8-pin)
ALED_IN(2-pin)
SLED (3-pin)
PLED (3-pin)
KEY (2-pin)
Table 2-2: Jumper of Slot Card with none SAF-TE Back
Plane Board
** The ALED_IN and SLED jumpers of slot card will be no function if the
Back Plane Board is none SAF-TE, thus they should not connect any cable
on these two jumpers. But the ALED_IN (from SCSI drive) cable and SLED
cable (from Drive Bay) must be connected together directly in order to light
up on Light-2 (Fig: 2-8) of Drive Bay during SCSI device access.
Fig 2-8: Indicator Light of Drive Bay
ASUS AP5000 Installation Guide
Functions
Cables Uses
Bus of Slot Card
None
Power of SCSI drive
None
Connector of wide SCS I
68-pin wide SCSI
cable
SCSI ID could be managed
SCSI_ID cable, 8-
from DA-BP4-1(S), refer to
wire,
Fig: 3-28
None
None
None
None
Power LED
PLED cable, 3-
wire, (Orange/
Black/Green)
Insure the SCSI drive
KEY cable, 2-wire,
power has been off while
(Black/Red)
Key Lock of Drive Bay
being opened. To protect
device during hot-swap.
Key Lock
Light-2 (SLED)
Light-1 (PLED)
Connect To
DA-BP4-1
SCSI drive
DA-BP4-1
ID jumper of
SCSI drive.
*Be sure the
target SCSI ID is
in the right order.
**None
**None
Light-1 of Drive
Bay
Key Lock of
Drive Bay
13