Dover Unified Brands Groen TDB-40 A TA/2 Benutzerhandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kommerzielle Lebensmittelausrüstung Dover Unified Brands Groen TDB-40 A TA/2 herunter. Dover Unified Brands Groen TDB-40 A TA/2 14 Seiten. Steam jacketed kettle
Seite drucken
WARNING
TURN OFF POWER AT THE CIRCUIT
BREAKER PRIOR TO INSTALLATION.
THE MIXER MUST BE INSTALLED BY
PERSONNEL WHO ARE QUALIFIED TO
WORK WITH ELECTRICITY. IMPROPER
INSTALLATION CAN RESULT IN INJURY
TO PERSONNEL AND/OR DAMAGE TO
EQUIPMENT.
ANY MECHANICAL OR ELECTRICAL
CHANGE MUST BE APPROVED BY THE
GROEN FOOD SERVICE ENGINEERING
DEPARTMENT.
WARNING
TO PREVENT POSSIBLE ELECTRIC
SHOCK, GROUND THE UNIT AT THE
TERMINAL PROVIDED.
WARNING
DO NOT CUT OFF THE GROUND PLUG
Equipment Description
The Groen TA/2 assembly is an electrically powered mixer with dual counter rotating
agitators, which is incorporated into Groen kettles of 20 or 40 quart capacity. The
agitator frame is constructed of tubular stainless steel and fitted with scrapers. It is
easily removed for cleaning.
The mixer has a variable speed drive with electrical speed control that powers on 1/2
HP motor.
For a description of the kettle component of your cooker/mixer, see the separate kettle
manual.
Your Groen mixer has been test operated at the factory and is furnished with all
internal wiring. It is complete and ready for final connection. A wiring diagram is
furnished at the rear of this manual. Installation is as follows:
1. Set the cooker/mixer in place and level it. If the mixer is a tilting model, confirm
that there is enough rear or side clearance, depending on model, and overhead
clearance to tilt the mixer safely through its entire tilting range. Provide enough
clearance to permit access for service as well. Fasten the cooker/mixer to the
floor or deck to reduce chances that the unit could tip over if unit is provided with
flanged feet.
2. Provide the proper electric power supply as specified on the electrical information
plate attached to the mixer. Observe local codes and/or The National Electrical
Code in accordance with ANSI/NFPA 70 - latest edition. The installation must
conform to the code that has the more strict requirements.
3. TA/2 mixer requires a seperate 120V, 60Hz, 15 Amp outlet. Unit is provided with a 6
ft. long cord and grounded plug.
4. Electrical service for the kettle will require a separate connection. See specific
kettle manual.
5. Use the following check list to confirm that the installation is correct.
Unit level
Adequate clearance for tilting
Access for service
Unit fastened down
Mixer power supply conforms to information plate and code
Electrical conduit and connections are waterproof
Mixer grounded
For instructions on installing the kettle component of your cooker/mixer, see the
separate kettle manual.
Installation
OM-TDB-20/40, TA/2
5