COMBAT HVE 400 Handbuch für Installation, Betrieb und Wartung - Seite 3
Blättern Sie online oder laden Sie pdf Handbuch für Installation, Betrieb und Wartung für Fan COMBAT HVE 400 herunter. COMBAT HVE 400 12 Seiten. Energy saving fans with control options
Seite drucken
Your safety is important to us! This
symbol is used throughout the
manual to notify you of possible
fire, electrical or burn hazards.
Please
when reading and following the
warnings in these sections.
Installation, service and annual
inspection of the controller must be done by an
electrician qualified in the installation and service of
control systems for heating equipment.
Installation, service and annual inspection of the heater
must be done by a contractor qualified in the installation
and service of gas or oil fired heating equipment.
Read this manual carefully before installation, operation
or service of this equipment.
The equipment must be applied and operated under
the general concepts of reasonable use and installed
using best building practices.
This equipment is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do
not play with the equipment.
For optimum heater performance and safe heating
conditions, inspect and maintain heater(s) before every
heating season and as necessary. Also, know and
maintain heater clearances to combustibles: see the
heater's Installation, Operation and Service Manual
for further details. If you require additional manuals,
contact Combat Heating Solutions Limited:
Tel +44 (0) 121 506 7700 or at www.combat.co.uk.
Control Options Specifications
Model
Control Unit Capacity (No. of Fans)
Manual On/Off
Manual Fan Speed Adjustment
Automatic Fan Speed Adjustment
Power 'On' Neon Indicator
Maximum Starting Current
Maximum Running Current
Section 1
pay
special
attention
1.1 Electrical Requirements
DANGER
Electrical Shock Hazard
Disconnect electrics before service
Equipment must be properly grounded.
Failure to follow these instructions can result in
death or electrical shock.
Failure to comply with the installation instructions will
invalidate the limited warranty.
All wiring must comply with current wiring regulations
and any local regulations which may apply. Always
switch off the electrical supply to the equipment and
disconnect it by removing the plug before working on
equipment.
Equipment must be electrically grounded in accordance
with local specifications and codes.
1.2 Check Installation Materials
Before proceeding with the installation of the Combat
Heatings Solutions HVE Fan, check the following
points:
1.2.1 Control Options
Each HVE fan has a built in thermostat that allows it
to turn on when the ambient temperature at the fan
exceeds the thermostat's setpoint.
WAC6
1
HVE400
HVE450
N/A
HVE650
N/A
Yes
Yes
No
Yes
[A]
3
[A]
1.5
Introduction
ME1.10
8
2
2
Yes
No
No
Yes
-
-
3