Dovre 500cc Installations- und Betriebshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Holzofen Dovre 500cc herunter. Dovre 500cc 19 Seiten.

Seite drucken

-5-

THE

STOVEPIPE

MUST

MINIMUM

THICKNESS OF 24 GAUGE BLACK OR BLUED

STEEL, OR STAI NLESS STEEL.

NEVER USE

GALVANIZED STEEL OR ALUMINUM PIPE.

THEY

CANNOT PROPERLY WITHSTAND THE EXTREME

TEMPERATURES OF A WOOD FIRE. THE CRIMPED

END OF EACH PIPE MUST POINT DOWNWARD, OR

TOWARD THE UNIT (SEE FIG. 7).

THIS KEEPS

ANY CONDENSCtTEFROM LEAKING OUT AT A PIPE

JOINT. IN ADDITION, SECURE EACH PIPE JOINT

WITH THREE SHEET METAL SCREWS TO PREVENT

SEPARATION DURING USE.

"00

Toward

Stove

O'mO<'""

FIG.

FACTORY BUill

CHIMNEYS

A FACTORY BUILT CHIMNEY IS A LISTED RESIDENTIAL TYPE AND BUILDING HEATING APPLIANCE

CHIMNEY.

GENERALLY, IT IS LESS EXPENSIVE TO CONSTRUCT A FACTORY BUILT RATHER THAN A

MASONRY CHIMNEY. A FACTORY BUILT CHIMNEY DOES NOT NEED A SPECIAL FOUNDATION AND CAN BE

SUPPORTED BY THE ROOFOR CEILING OF YOUR HOUSE. FACTORY BUILT CHIMNEYS COME IN A NUMBER

OF SIZES. YOUR DOVRE UNIT REQUIRES A 6" DIAMETER PIPE. BE SURE TO FOLLOW THE CHIMNEY

MANUFACTURERS INSTALLATION INSTRUCTIONS.

STOVE PIPE OR CHIMNEY CONNECTOR

YOUR DOVRE UNIT NEEDS 6" SINGLE -WALL CHIMNEY TO CONNECT THE UNIT TO THE CHIMNEY FLUE.

BY PLACING THE UNIT AS CLOSE TO THE CHIMNEY AS ALLOWED BY CLEARANCES TO COMBUSTIBLES,

YOU WILL KEEP THE STOVEPIPE AS SHORT AND STRAIGHT AS POSSIBLE.

THIS WILL ALLOW THE

SMOKE AND EXHAUSTED GAS TO FLOW SMOOTHLY INTO THE CHIMNEY.

HORIZONTAL SECTIONS OF

STOVEPIPE SHOULD BE KEPT SHORT, AS THEY COLLECT SOOT AND CREOSOTE MORE EASILY AND,

THEREFORE, REQUIRE CLEANING MORE OFTEN.

ANY HORIZONTAL RUN OF STOVEPIPE MUST HAVE A SLIGHT RISE AWAY FROM THE UNIT OF 1/4" PER

FOOT OF PIPE. THIS WILL DIRECT ANY CONDENSCtTEFLOW BACK INTO THE UNIT WHERE IT CAN BE

BURNED SAFELY.

A LISTED DOUBLE -WALL

CHIMNEY CONNECTOR OR LISTED CONNECTORS MAY BE USED IN

CONJUNCTION WITH AN OPTIONAL BACKSHIELD TO REDUCE THE CLEARANCES TO THE BACKWALL. SEE

THE CLEARANCE TABLE IN THE FOLLOWING SECTION.

CATALYTIC PROBE THERMOMETER

(CPT)

EACH UNIT IS PROVIDED WITH A TEMPERATURE

PROBf AND AN ACCESS HOLE ON THE TOP PLATE

OF THE UNIT. THE PROBE IS PROVIDED IN THE

CORRECT

LENGTH

MONITOR

THE

TEMPERATURE OF THE GASES COMING OUT OF

THE CATALYTIC COMBUSTOR (SEE FIG. 8).

FIG.