Dow ENERFOAM Installationsempfehlungen - Seite 2

Blättern Sie online oder laden Sie pdf Installationsempfehlungen für Farbspritzgerät Dow ENERFOAM herunter. Dow ENERFOAM 4 Seiten. Professional foam sealant

Seite drucken

installation information . commercial/residential

t Y P i c a l a P P l i c a t i o n S

Outdoor water faucet

Pipe penetration

Electrical wire penetration

Electrical outlet*

®™Trademark of The Dow Chemical Company ("Dow") or an affiliated company of Dow

*Foam should only be dispensed around the outside of the box, not inside.

Fireplace gas line

Sewer plumbing penetration

Wall-ceiling juncture

Attic hatch

HVAC vent

a P P l i c a t i o n

Gun-applied verSion:

1. Adjust flow control screw on

back of gun to an open position.

Immediately press trigger to fill

gun with foam while dispensing

into an appropriate waste

receptacle.

2. Keeping can inverted, insert

applicator nozzle into the

penetration to be filled and

begin dispensing foam slowly.

Fill gap less than 1/3 full to

allow for proper expansion.

CauTion:

do not inject the foam sealant

into blind six-sided cavities, such

as window mullions. The foam

must be exposed to atmospheric

moisture to thoroughly cure.

Tip: using grease or petroleum

jelly in the adapter of the gun

may reduce possibility of foam

gluing the can on the gun.

Tip: apply foam in a continuous

bead, with no voids or breaks, to

achieve an effective seal.

3. The foam dispensing gun is

recommended to control size

of the foam bead (from 1/8"

to 3" [3 mm to 75 mm]). This

is achieved by squeezing the

trigger on the foam dispensing

gun or by adjusting the flow

control knob on the back of the

gun to set how far the trigger

can be pulled (Figure 5).

Figure 5