Combi-Camp FLEXI Tent&Trailer Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Wohnmobile Combi-Camp FLEXI Tent&Trailer herunter. Combi-Camp FLEXI Tent&Trailer 10 Seiten.
Seite druckenSetting up the tent
First, remove the cover. Use the jockey wheel and the 2 corner steadies to make the trailer
level. (After the set-up turn the nose wheel back up again). The wheels continue to be
supports!
On soft soil, use the included boards underneath the supports. Put down a groundsheet
protector where the luggage compartment comes down (under the fold-up bed).
Set the bed legs straight up and bring the slatted base over – make sure it doesn't slip down.
The gas springs make this easier. See photo 1.
For the Comfort model, lower the slatted base support pole in the trailer.
Loosen the black band that keeps the mattress and the frame in place. Fold the tent out. See
photo 2.
If you have a groundsheet, put a groundsheet protector on the ground and the groundsheet
on top of it. Have this groundsheet border the luggage compartment and put the middle
carefully in place. Fasten it with pins.
Attach the T-bar, together with the stand, to the awning frame. You can then pull the frame
over together with the tent. The easiest way to do it is to push up the rear while pulling on the
front. See photo 3.
Extend the frame on both sides until the pin comes out and fasten it with clamps. If the tent is
wet and shrunken, you may want to move the clamps over the pins. Set both support poles in
the corners angling forwards along with the canvas.
The next step is setting up the middle bar between the beds. This ensures that both separate
frame arches remain at the same distance from one another. Put the middle bar as high as
possible. Close the zippers at the back of the trailer.
Now zip the awning to the groundsheet OR secure the tent on all sides with pegs. Before
tightening the lines, zip up the front wall.