Amplicomms TV3500 Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Kopfhörer Amplicomms TV3500 herunter. Amplicomms TV3500 15 Seiten.

There is a "beep" tone as confirmation for every effective key press on TV3500

remote control. Some special tone will be used for below listed case:

1. 2 beeps will be heard when the volume level is reaching the maximum or

minimum.

2. 2 beeps will be heard when the left and right sound level difference is

reaching the maximum.

3. A long beep will be heard when the left and right sound level is equal

balanced.

4. 2 beeps will be heard when EQ1 ( Flat ) is selected.

In active mode, press the

transparency mode. The headset indicator will switch from blue to red. The

microphone hole is at the front of the headset to pick up the sounds of your

surroundings. Make sure that the microphone opening is not covered!.

When the microphone is switched ON, you will hear your surroundings louder.

You can hear for example your door bell or your conversational partner even

when you are wearing the headset.

To switch back to the TV listening mode, press the

headset indicator will turn to blue and you will hear the sound from the audio

source again.

To save power, the headset will enter sleep mode when there is no signal

detected for approximately 5 minutes. To wake up the headset, press

button.

Note : To turn OFF the headset, press and hold the

The headset LED will turn OFF.

button will switch from TV listening mode to

button again. The

button for 3 seconds.