Downeaster DED LP Besitzer-/Bedienerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Besitzer-/Bedienerhandbuch für Zubehör für Kraftfahrzeuge Downeaster DED LP herunter. Downeaster DED LP 20 Seiten. Dump body scissor hoist
Seite drucken
Your DownEaster dump body will come fully assembled to the SUB frame and hoist attached. (unless ordered
otherwise).
This body was designed for Cab & Chassis trucks with a frame width of 34" only. Any other frame width will
require custom mounting, responsible by the installer.
WARNING DO NOT ATTEMPT TO INSTALL ON A PICK UP BOX REMOVAL OR ANY OTHER VEHICLE NOT
DESIGNED FOR 34" FRAME WIDTH
Preparation
Measure the truck frame length. For 60" CA (Cab to axle), maximum frame length from cab should not
exceed 111". If frame is longer, or has been modified, or extended previously, frame will have to be
shortened. (See your brands Upfitter's Guide for frame cutting and modification procedures.)
The body comes with optional rear bolt kit, if welding is not desired, applicable or an option. See the drill
layout below (Fig. 1-A) for drilling template. Grade 8, 1/2" hardware is utilized. Requires a 1/2" or 17/32 drill.
If an obstruction prevents the drilling of both holes, the provided sill plates must be used as close as to the
rear of the sub frame as possible, within 3" of the front of the rear hinge angle. Sill plate may be reversed to
accommodate obstructions. Use hardware kit DEDP376 provided. Some manufactures recommend sub
frame be attached to chassis in 3 places. If so, a second set of sill plates will be needed for installation, unless
welding of rear hinge has been utilized.
INSTALLATION
1-C
10
Blank cut outs have been provided
(1-C), for wiring and fuel filler
tubes.
1-B
1-A