Dahua SG4028 Schnellstart-Handbuch - Seite 13
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Schalter Dahua SG4028 herunter. Dahua SG4028 17 Seiten. 16/24-port managed gigabit switch
Seite drucken
DB9 pin
2
3
5
3.2.3 SFP Port
Background Information
The signal is transmitted through laser by optical fiber cable. The laser conforms to the requirement
of level 1 laser products. To avoid injury of eyes, do not look at the 1000 Base-X optical port directly
when the device is powered on.
Before installing SFP module, wear antistatic gloves, and then wear antistatic wrist strap. Make sure
that the antistatic gloves and the antistatic wrist strap are in good contact.
Procedure
Step 1
Lift the handle of SFP module upward vertically, and then stuck it to the top hook.
Step 2
Hold the SFP module by both sides, and push it gently into the SFP slot till the SFP module
is firmly connected to the slot.
Both the top and bottom spring strip of the SFP module are firmly stuck with the SFP slot.
3.2.4 GND
Normal GND of the device is the important guarantee for device lightning protection and
anti-interference. You should connect the GND cable before powering on the device, and power off
the device before disconnecting the GND cable.
Table 3-1 Pin description
RJ–45 pin
3
2
5
Figure 3-6 SFP module structure
Figure 3-7 SFP module installation
12
Signal
RXD
TXD
GND
Description
Receiving data
Sending data
GND