Amplifier Research 100A250 series Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für Verstärken Amplifier Research 100A250 series herunter. Amplifier Research 100A250 series 19 Seiten.

Seite drucken

Amplifier Research 100A250 series Handbuch

Model 100A250A

2.2.2

2.2.2.4.2 IEEE-488 device address selection (continued)

Device Address

2.2.2.5

Command Set Format

Each command is composed of one alpha character, up to four numeric parameters, and a

command termination character. The command termination character is the "line feed" command,

which is denoted and entered as <LF>. Commands are case-sensitive and must be entered in upper

case only in order to be recognized.

2.2.2.6

IEEE-488 Communications

For IEEE-488 communications, the "End or Identify" (EOI) control line may also be used for

command termination. When sending commands to the Model 100A250A via the IEEE-488 bus,

terminate each command with a <LF>, an EOI, or both. No characters are permitted after the

<LF> or EOI; the 100A250Ainterprets characters following the <LF> or EOI as the start of the

next command. When an error condition is present at the Model 100A250A, the "Service Request"

(SRQ) line is asserted; the operator can then perform a serial poll operation. The Model 100A250A

error code (in binary) is contained in the returned serial poll status byte (STB). These error codes

are defined in Table 2-2.

Remote Operation (continued)

IEEE-488 Device Address Selection

Switch 5

off (0)

on (1)

Table 2-1

Switch 4

Switch 3

off (0)

on (1)

off (0)

on (1)

Manual Text

Switch 2

Switch 1

off (0)

on (1)

off (0)

on (1)

off (0)

on (1)

off (0)

2-4

REV -