AmpliVox SW222A Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner AmpliVox SW222A herunter. AmpliVox SW222A 8 Seiten. 50 watt portable pa system with

Seite drucken

OPERATION

Plug wired handheld microphone into the "DYNAMIC" jack. Turn amplifier on. Turn microphone on and talk into



microphone. Rotate "VOLUME" control knob to obtain desired loudness level.

For Model SW222A / SW223A / SW224A with the built-in wireless receiver, the "ON-OFF" switch is located next



to main power switch of amplifier. Make sure both transmitter and receiver are on same frequency channel. Turn

"ON" wireless transmitter (Bodypack S1690T) or (Handheld S1695). RF LED on amplifier will light, meaning

that it is receiving signal. If RF LED does not light, check channel numbers.

For future reference a



BLUETOOTH PAIRING

Locate on/off switch on side of chassis.



Slide switch to ON. A blue LED will start to flash.



On your Bluetooth device menu select VUBT2 to start pairing.



When successfully connected, the blue LED will stop blinking and remain lit.

MICROPHONE STORAGE

STORAGE COMPARTMENT: Compartment will only hold one handheld microphone. Model SW223A /



SW224A will also hold the bodypack and lapel microphone. The headset microphone can be placed on top of

setup information area before closing the top half of case. The foam inside of the case half will hold headset in

place.

BLUETOOTH

RECEIVER

Model SW224A shown with

2nd wireless installed.

has been printed on top of the amplifier chassis.

SET-UP GUIDE

1-800-572-2194 • DISPLAYS2GO.COM