AmpliVox SW805A Benutzerhandbuch
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken AmpliVox SW805A herunter. AmpliVox SW805A 4 Seiten. 50 watt stereo amplifier pa system
Auch für AmpliVox SW805A: Benutzerhandbuch (7 seiten)
Seite drucken
MULTIMEDIA STEREO AMPLIFIER W/INTERNAL WIRELESS
SET UP:
INSTALL POWER SUPPLY
The Battery pack is standard. Optional Power Supplies may be substituted. Model S1460, International
AC Adapter (110/220V, 50/60Hz). Model S1452, 12 Volt DC adapter (automotive cigarette lighter plug-
in). Model S1465, NiCad battery Pack.
TO INSTALL OR REPLACE BATTERIES
Slip fingernail under battery door on back of amplifier and slide it out. Remove battery holder from
amplifier. Insert 10 new Alkaline "D" cell batteries, observing polarity, or replace with S1465 NiCad
battery pack. Carefully replace battery holder. Slide door back into place.
Do not mix battery types or attempt to recharge alkaline batteries - equipment damage, safety hazard or
fire could result.
TO OPERATE:
Insure the microphone is plugged into DYNAMIC microphone jack. Insure the speaker is plugged into
either SPEAKER jack. Turn amplifier on (large rocker switch located on the front of the amplifier). The
red light will go on, showing that power is available. Push switch on microphone to the on position.
Rotate VOLUME control knob to obtain desired loudness level throughout the coverage area.
ON-OFF
When power switch is in the ON position, the red light will be on.
DC IN
Connection for optional power adapter:
•
S1460 International AC Adapter/Recharger (110/220V, 50/60Hz)
•
S1452 12 Volt DC (automotive cigarette lighter) Adapter
AUX OUT
Connection for 12 to 15V DC accessory.
VOLUME
Rotate clockwise to increase amplification.
MICROPHONE INPUTS
There are three microphone inputs, which can be used simultaneously:
DYNAMIC
CONDENSER
WIRELESS
PORTABLE PUBLIC ADDRESS AMPLIFIER
MODEL SW805A
- for standard dynamic cartridge microphones
- for electret or condenser microphones, which require phantom power
(supplied from the amplifier)
- accepts line-level output from wireless microphone receiver