COMCRAFT 1GTX-RM Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken COMCRAFT 1GTX-RM herunter. COMCRAFT 1GTX-RM 8 Seiten. Single port 10/100/1000 baset tap stand alone, portable model and rack mount model
L A N & W A N T E S T E Q U I P M E N T
P a g e 6
3. Installation
1. Power both network devices, do NOT power the TAP
Note: A powered TAP will always correct a wrong cable setup.
Connect the network using category 5e UTP cables.
a. If the two (2) network devices are of DTE and DCE type, use two (2)
straight cables.
b. If the two (2) network devices are of the same type (2*DTE or 2*DCE)
use one straight and one cross-over cable.
* The connected network devices show LINK (or Activity). If there is no
LINK, change one of the cables by an opposite type.
2. When two devices are connected on the network ports, the two speed
LEDs blink simultaneously to indicate the negotiation of the highest
mutual Speed. When the connection is establish, the Speed LEDs
indicates the network speed:
♦ the left LED light for a 10Mb connection.
♦ the right LED light for a 100Mb connection.
♦ both LEDs light for a Gb connection.
If no mutual speed is detected, the two LEDs blink alternatively.
* Network activity is shown on the Activity LEDs of NetworkA and Net-
workB.
3. Connect the two Monitor Ports to the analyzer using straight or cross-
over CAT5e cables.
The Monitor Ports are at the speed of the network ports.
The Monitor Ports Link LEDs light when link is found.
* Activity received into NetworkA and NetworkB will be mirrored on the
respective Monitor Ports and blink the ACTIVITY LEDs.