Amprobe ACD-23SW Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Messgeräte Amprobe ACD-23SW herunter. Amprobe ACD-23SW 20 Seiten. Digital clamp meter

OPERATION

AUXILIARY FEATURES Push Button

°F/°C/R/e Button (ACD-23SW only) °F/°C/R/e

Use the "°F / °C " button to select the °F or °C Temperature ranges.

Use the "R/e" button to select the Resistance or Continuity ranges

HOLD.

Data hold freezes the reading present on the LCD at the moment the button is

pressed.To use this menu feature, set up the meter for the type of measurement

and range desired.

Connect the test leads to the circuit / component to be measured and then press

"HOLD" push button. The LCD reading will freeze and display "HOLD". You may

now remove the test leads and the reading will not change until you press Hold

again.

RANGE Push Button

This function allows the user to select the range of a function that does not show

"RANGE" on the LCD.

Backlight auto-off approx. 60 sec.

This meter will automatically turn the power off after 10 minutes. To disable the

APO, set the meter to off position, press and hold the (

while turning the rotary knob to the desired range position. Release the button

when LCD displays normally. Note "APO" annunciator is missing from the LCD.

1. Set the Function Switch to L

2. Connect the test leads: Red to +, Black to COM.

3. Connect the test probes to the circuit test points. Refer to Fig.1

4. Read the display. If necessary, correct any overload (OL) conditions.

1. Set the Function Switch to K.

2. Connect the test leads: Red to +, Black to COM.

3. Connect the test probes to the circuit test points. Refer to Fig.2

BACKLIGHT) button