Follett Advantage FZRADV25-LB Betriebs- und Wartungshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Betriebs- und Wartungshandbuch für Gefrierschrank Follett Advantage FZRADV25-LB herunter. Follett Advantage FZRADV25-LB 20 Seiten.

Follett Advantage FZRADV25-LB Betriebs- und Wartungshandbuch

Installation

The equipment must be transported and handled exclusively in upright position, in observance of the instructions
printed on the packing . This precaution is necessary to avoid contamination of the refrigerant circuit with
compressor lube oil with resulting valve and heat exchanger coil failure and problems starting the electric motor or
the risk of gas leak . The manufacturer is not responsible for any problems due to transport executed in conditions
other than those specified herewith . The equipment is secured to a wooden pallet base, wrapped in a plastic film
and packaged into a three waves carton box . The equipment must be handled using a fork lift truck or a pallet
truck with suitable forks (fork length at least equal to 2/3 length of unit) .
1. Remove packing material .
2. Remove accessories from inside the unit .
3. Carefully slide the cabinet off the skid .
4. Use gloves when handling the carton box or the wooden base to
protect the hands from splinters .
5. Position the equipment with the help of a level . Remove the
protective PVC film from the external surfaces of the unit .

Install shelves (if equipped) and power up

1. If freezer is equipped with shelves, remove bag containing shelf
supports and position them in desired locations on each pilaster
and insert shelves (Fig. 1) .
2. Plug freezer into a 115 V 60 Hz 15A outlet .

Power the Unit

1. Plug in unit and press power button located on rear, right-hand
corner .
Follett Advantage FZRADV25-LB Freezers
Do not tilt any unit further than 30° off vertical during uncrating or
installation
Refrigeration module area contains mechanical, moving parts. Keep
hands and arms clear of this area at all times. If access to this area is
required, power to unit must be disconnected first.
DANGER
Fig. 1
1
2
3
5