Follett C25R5A/W Installationshandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Installationshandbuch für Spender Follett C25R5A/W herunter. Follett C25R5A/W 13 Seiten. Ice and water dispenser
Auch für Follett C25R5A/W: Betriebs-, Service- und Teilehandbuch (17 seiten)

Seite drucken

7. Place free end of tube in cup of hot water to soften, slip supplied hose clamp onto tube and push tube onto exit port

of evaporator. DO NOT TWIST HOSE WHEN SECURING TO EVAPORATOR.

8. Fasten tube on port with hose clamp, being sure that clamp is positioned on evaporator side of flange.

9. Tighten clamp.

Installing integral icemaker

Dispensers with integral icemakers cannot be mounted on legs. They must be bolted to

counter. Use gloves or a cloth when lifting icemaker to protect hands from sheet metal

edges.

1. Remove two screws located under front access panel of dispenser.

2. Pull bottom of access panel forward and lift off.

3. Remove icemaker top and louvered panel from right side of icemaker.

4. Remove hold down bracket from front of icemaker base.

5. Lift icemaker onto dispenser top and slide into position, compressor end first,

locating icemaker flush with front of dispenser.

6. Reinstall hold down bracket on front of icemaker.

7. Remove ice transport tube from evaporator nozzle.

8. Insert loose end of ice transport tube into bracket and pull up to seat (see drawing).

9. Push ice transport tube onto compression nozzle and secure with hose clamp.

10. Push transport tube behind clip on float bracket to prevent contact with fan blades.

11. Place end of drain hose in hot water to soften and connect to elbow attached

to evaporator drain line.

12. Connect electric twist locks.

13. Connect plastic water line to fitting at float tank.

14. Reinstall side panel and top on icemaker.

15. Reinstall front access panel on dispenser.

Cleaning and sanitizing before use

Warning: Disconnect power before cleaning dispenser.

Using solutions below, clean and sanitize storage area of dispenser before starting up unit.

Solution A: Prepare cleaning solution (200 ppm of available chlorine content) of Ecolab Mikro-chlor Cleaner

or equal chlorinated detergent. Cleaning solution temperature must be at 75˚F – 125˚F (24˚C –

52˚C).

Solution B: Prepare sanitizing solution (50 ppm of available chlorine content) of Ecolab Mikro-chlor Cleaner

or equal chlorinated detergent. Sanitizing solution temperature must be at 75˚F – 125˚F (24˚C –

52˚C).

1. Working inside storage area, remove center thumbscrew from dispense wheel, tilt wheel up toward back to clear

baffle and lift wheel out.

2. Wipe all bin and wheel surfaces with Solution A .

3 Rinse thoroughly with clear, potable water.

4. Wipe with Solution B to sanitize.

5. Reinstall dispense wheel.

Start-up

1. Clean and sanitize ice storage area of dispenser in accordance with instructions above before making ice.

2. Turn on icemaker and begin to make ice (icemaker should start within 45 seconds with power and bin signal

supplied).

3. After approximately 30 minutes, test dispenser for proper dispensing.

(in top of dispenser cabinet)

Ice tube

bracket

Mounting pin

Plate

Gasket

Icemaker

base

Ice

deflector

ICDI220

Cap tube

bracket