Advanced Avionics HyperBlast Benutzerhandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Batterieladegerät Advanced Avionics HyperBlast herunter. Advanced Avionics HyperBlast 7 Seiten.
Seite druckenBasic Use of the Charger
The LaserBlast HyperBlast Charger has several safeguards to prevent overcharging and
maximize the life of your batteries.
On batteries with 3 leads, the charger will monitor the temperature of the battery
and shut down over 50 deg. C.
The charger tests itself (POWER ON SELF TEST, or POST) every time it is
turned on. If the LED does not light for 2 seconds when the charger is first turned on,
that channel of the charger is not functioning correctly.
After 8 hours on a trickle charge, the charger will set the charge current to 0.
The charger will not allow more than 150% of the capacity of the battery to be
applied to the battery during rapid charge.
The charger will shut down if it cannot reach a minimum voltage after detecting a
battery has been plugged in. It will blink at 5 per second in this case.
The charger circuit board contains a temperature sensor that monitors the charger
temperature and will shut down if it exceeds 70 deg. C.
The charger will not restart the rapid charge sequence if the battery is already more
than 75% full. It will finish the charge in trickle charge mode.
If you unplug a battery and plug it back in, then the charger will restart its charging
sequence, including a minimum 10 minute rapid charge. This could potentially
overcharge a battery and should be avoided.
The power supply in the battery charger has thermal and overvoltage protection. If
it sees an overload, it will turn itself off automatically. To reset it, you must turn the
charger off for at least 5 seconds and then turn it back on.