DPCAV PANDORA Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Kontrolleinheit DPCAV PANDORA herunter. DPCAV PANDORA 7 Seiten. Pan & tilt kit

Seite drucken

Final Assembly:

Install the top Stringer (item 5) on the chassis at Slots DD. Use a small amount of epoxy or

solder. Use it sparingly since it may be necessary to remove the stringer for repairs or perhaps

to upgrade to the optional 5VDC Voltage Regulator in the future.

Using two 2-56 x 3/8" machine screws and nuts (with Loctite), install the HS-81 pan servo

(with rubber grommets and metal eyelets) to the Base Plate (item 10). Using the retaining

screw supplied with the servo, attach the servo to the chassis mounted servo wheel. Be sure

to install it so that servo center results in a forward looking camera pan position. For best

results, set your R/C transmitter's EPA/ATV mix for maximum servo travel. Verify that the pan

servo is able to rotate without hitting any chassis obstructions. By the way, the Pan Backing

Plates (items 14 and 15) are used to help strengthen the model where the Pan Base is

installed in it.

While using your R/C transmitter, adjust the tilt linkage for best servo movement. Ensure that

the servo is not allowed to stall or it will be damaged. It will be necessary to adjust your R/C

transmitter's EPA/ATV mix feature to set the maximum lower and upper travel ranges.

Revision-C Voltage Regulator Option:

The top Stringer (item 5) can be replaced with the optional

5VDC voltage regulator board. It is compatible with the 5-volt

KX-131 (KPC-S226CB) board camera. The input voltage

may range from 6.0VDC to 9.0VDC.

Note: On the Rev-C board, the 3-wire signal order on the

Battery input is NOT the same as the Camera side. Please

consult the photo on the right for full details.

The Voltage Regulator requires assembly. It uses SMD

components so advanced soldering skills are needed. The electronic components are

available from mouser.com for about $10.

QTY ITEM

.1uF

47uF 6V

47uF 16V

22uH

DL4001

KF50BDT

(

), www.dpcav.com

ANDORA

REV-C

REF DESCRIPTION

Capacitor

Inductor

Diode

LDO VREG IC, 5V

Page 7

MOUSER PART NUMBER

80-C0805C104J5R

80-T491B476K006

80-T491C476K016

80-CBC3225T220MRK

833-DL4001-TP

511-KF50BDT