CardAccess ZGB20 Schnellstart- und Installationshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Schnellstart- und Installationshandbuch für Drahtloser Zugangspunkt CardAccess ZGB20 herunter. CardAccess ZGB20 12 Seiten. Security sensor bridge v2
Seite druckenWelcome and congratulations on your purchase of the Card Access Security Sensor Bridge. This Quick Start &
Installation Guide is an overview of configuring your Security Sensor Bridge with a Control4 System. This guide assumes
that you are a qualified and trained Control4 dealer.
*NOTICE: THE SECURITY SENSOR BRIDGE V2 IS INTENDED FOR HOME AUTOMATION PURPOSES ONLY. THIS
IS NOT A SECURITY SYSTEM.
Introduction
The Card Access Security Sensor Bridge is a device capable of receiving and interpreting signals from GE/ITI
sensors and integrating these signals with a Control4 System via the Control4 ZigBee wireless mesh. This device
gives the homeowner the ability to utilize the wide range of GE sensors available as accessories to the Control4
system.
The device consists of a self-contained, wall-mountable bridge in a plastic enclosure. It is powered by a 12V DC
adapter.
Specifications
ZGB20 Specifications
Dimensions
Weight
Maximum Ambient Operational
Temperature
Power Input
Operational Environment
Site Requirements and Wiring Options
•
Allow at least 10 inches of clearance above the enclosure for the antennas.
•
Avoid mounting locations that expose the module to moisture.
•
Avoid areas with excessive metal or electrical wiring including furnace and utility rooms. If unavoidable,
mount on or near metal with the antenna extending above the metallic surfaces as shown in Figure 1.
•
Ensure that an electrical source is accessible for the DC power adaptor.
Figure 1 - Mounting on or near metal
Tools and Supplies Needed
To complete the installation, you will need the following tools and supplies:
•
Screwdrivers
_________________________________________________________________________________________________________________________
Card Access Security Sensor Bridge V2
Quick Start & Installation Guide
6.75" x 4.5" x 1.5"
(excluding antennas)
0.5 Lbs
(0.23Kg)
140° F (60° C)
12VDC, 100mA
Type 1 Device shall be mounted in a dry, moisture-protected location.
Page 2 of 12
Card Access, Inc.