CardAccess inhome IGA10A Installationshandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Installationshandbuch für Controller CardAccess inhome IGA10A herunter. CardAccess inhome IGA10A 8 Seiten. For monitoring and controlling garage doors and enabling automation events
Seite druckenEasy Installation
The InHome Garage Automation Package is designed for quick installation with high reliability. The Card Access InHome
Wireless Contact Switch and Relay installs quickly. The two innovative rail-mounted GE garage door contacts install
vertically on the door channel (eliminating messy floor mounted contacts and cracked cement) and are both connected to
the InHome Wireless Contact Switch. An entire automation package can easily be installed by experienced installers in
as little as 30 minutes.
Applications
Everyone hates waking up in the morning only to discover the garage door was left open all night. Now the InHome
Garage Automation Package from Card Access eliminates worries for Control4-automated homeowners. When used in
Control4 systems, homeowners can monitor their homes from miles away.
Use the InHome Garage Automation Package with new or existing garage doors to wirelessly add capabilities to Control4
projects like:
Remote controlled garage open and close
Automatic time-based garage open or close
4Sight remote garage open and close
Home lighting scene changes (and other home automation events) based on garage door open/close states
LED keypad status of garage door open/close states
!!!
WARNING !!!: To prevent accidental closing of garage doors on
obstructed or otherwise occupied garage doorways, the InHome
Garage Automation Package MUST ONLY BE INSTALLED on garage
doors WITH "SAFETY BEAM" CAPABILITIES that are designed to
detect garage doorway obstructions and prevent door closure.
Control4 Compatibility
NOTE:
The InHome Garage Automation Package has been tested and is designed to work with
Control4 Software version 1.3.2. All necessary drivers for the Package are included in this
Control4 version.
Installation
Quick Hardware Installation Instructions
For a typical two-door garage installation, connect the InHome Garage Automation Package contents to the garage doors
and garage motor drives in the following manner:
1. Install the InHome Wireless Contact Switch on a wall between the two garage door rail assemblies.
2. Install the two (2) GE Model 2317A-L Rail-Mounted Magnetic Door Contacts on to the two garage door rail
assemblies, and connect them to the InHome Wireless Contact Switch
3. Install the InHome External Thermistor on an outside wall and route its wire back into the garage and connect it to
the InHome Wireless Contact Switch.
4. Install the InHome Wireless Contact Relay on the ceiling between the two garage door motor drives, connect its
external power supply and plug it into a ceiling outlet.
5. Using standard AWG 18-28 wiring, connect the garage door motor drives to the two relay connections on the
InHome Wireless Contact Relay (simply duplicate the wiring scheme from the motor drives to the existing garage
door buttons already installed in the garage area)
Detailed Instructions for Monitoring Garage Door Open/Closed States and External Temperature Values
To install the needed hardware to support Control4 monitoring of the open and closed state of the garage doors, please
install the hardware referenced in Figure 2 below as you complete the following steps:
_________________________________________________________________________________________________________________________
™
™
Card Access
InHome
Garage Automation Package Installation Guide / Wiring Diagram
Monitor and Control Garage Doors, and Enable Automation Events in the Control4-Automated Homes
Page 4 of 8
Card Access, Inc.