Cardax Prox Plus Mifare Hinweise zur Installation - Seite 2

Blättern Sie online oder laden Sie pdf Hinweise zur Installation für Kartenleser Cardax Prox Plus Mifare herunter. Cardax Prox Plus Mifare 16 Seiten.

4 x Self-tapping pan-head screws

4 x 10 mm plastics screw caps

1 x M4 x 12 tamper-resistant Torx-head machine screw

Power supply requirements

Each Prox Plus Mifare reader consumes 200 mA from a 13.6 V

± 15% DC supply.

Use a linear-regulator power source.

Note:

Switch mode power supplies are not recommended as they may

reduce the read range of the Prox Plus Mifare reader.

Firmware

The reader firmware has two variants. These are set out in the

table.

Firmware identification Capability

vR1.06 and earlier Reads Philips Mifare 1K cards.

vR2.05 and later

Depending on the type of firmware, there is a difference in the

sequence displayed on the reader's screen after power has been

applied.

Reads Philips Mifare 1K cards

Reads all sectors of Philips Mifare 4K cards

Part number 3C4480 R10

May 2005