AMR LS-3030 Anweisungen zur Installation und Einrichtung - Seite 2

Blättern Sie online oder laden Sie pdf Anweisungen zur Installation und Einrichtung für E/A-Systeme AMR LS-3030 herunter. AMR LS-3030 4 Seiten. Analog output device, belt slip/sequence and control

Seite drucken

INSTALLATION

Step 1

Select a suitable mounting location for the module. The primary location is the tail pulley and the

secondary location is the take-up pulley.

Step 2

Weld or otherwise attach a piece of 1/2" keystock or a large nut to the roller edge as shown in

figure 1.

Step 3

Using the clamp and bracket provided, position the module so that the pick-up-face is as close to the

keystock as possible without touching to prevent damage and wear. This distance should not

exceed 3/8" or nuisance tripping may result. Optimum distance is 1/4" . An indication light is built

into the rear of the module in order to check proper positioning and operation.

Note: Little Speedy should be mounted between 1/8 and 3/8 from a moving target. The movement

of the target across the magnetic field of the sensor will reflect the speed of the target you are

monitoring. For example, if mounted on the tail pulley of a conveyor belt, as the spokes or even a

welded bolt rotate past the speedy's sensor it will monitor the rate at which it passes. This makes it

possible to monitor for low belt speed ( meaning excessive amount of material ) or high belt speed

( meaning little to no material on the belt ).

LS - 3030 " Little Speedy "

Little Speedy

mounting 1/8" to 3/8" from target