DR Power Equipment PILOT 2C Sicherheits- und Betriebsanleitung - Seite 20

Blättern Sie online oder laden Sie pdf Sicherheits- und Betriebsanleitung für Pinne DR Power Equipment PILOT 2C herunter. DR Power Equipment PILOT 2C 20 Seiten. 2-cycle tiller cultivator

DR Power Equipment PILOT 2C Sicherheits- und Betriebsanleitung
Daily Checklist for the DR 2-CYCLE TILLER CULTIVATOR
To help maintain your DR 2-CYCLE TILLER CULTIVATOR for optimum performance, we recommend you follow this checklist each
time you use your machine.
Prior to performing any maintenance, you must first shut off the Engine; wait five (5) minutes to allow parts to cool and
disconnect the Spark Plug wire, keeping it away from the Spark Plug.
[ ] FUEL: Fill the Fuel Tank with a fresh unleaded gasoline/2-cycle oil mixture. See page 10.
[ ] ENGINE: It is very important to keep the Engine clean. Remove dirt and other debris from the Engine Cooling Fins. A dirty
Engine retains heat and can cause damage to internal Engine components.
[ ] HARDWARE: Check all nuts and bolts to be sure that the components are secure.
[ ] FRAME: Check all welds to be sure that the Frame is intact and secure.
[ ] TINES: Make sure that the Tine Assemblies and Tine Shield are free of accumulated debris.
[ ] ENGINE AIR FILTER: Clean engine air filter before each use to ensure optimal engine performance.
End of Season and Storage
Prior to performing any maintenance, you must first shut off the Engine; wait five minutes to allow parts to cool and disconnect
the Spark Plug wire, keeping it away from the Spark Plug.
If your DR 2-CYCLE TILLER CULTIVATOR will not be operated for more than 30 days, we recommend using a fuel stabilizer.
This will prevent sediment from gumming up the carburetor. If there is dirt or moisture in the fuel or tank, remove it by
draining the tank. Completely fill the tank with a fresh fuel mixture and add the appropriate amount of stabilizer or fuel
additive. Run the Engine for a short time to allow the additive to circulate?
Remove the Spark Plug and pour about 1 ounce of motor oil into the cylinder hole. Replace the Plug and pull the Recoil Starter
Rope until you feel strong resistance. This will coat the Piston and Cylinder Wall to prevent moisture buildup.
Clean or replace the Engine Air Filter.
Clean dirt and debris from the Engine Cylinder Head Cooling Fins, Debris Screen, and Muffler.
Clean out residual debris from the under the Tines Hood and Tine Assemblies.
Touchup all rusted or chipped paint surfaces. Sand them lightly before painting.
Be sure all Nuts, Bolts, and Screws are securely fastened.
Inspect moving parts for damage and wear; replace if necessary.
If possible, store your DR 2-CYCLE TILLER CULTIVATOR inside, but not near an open flame or spark such as found in a water
heater.
After the DR 2-CYCLE TILLER CULTIVATOR has cooled, cover the machine with a suitable protective cover that does not retain
moisture. Do not use plastic as this material cannot breathe; it also allows condensation to form, which will cause your
machine to rust.
8 0 0 H I N E S B U R G R O A D , S O U T H B U R L I N G T O N , V E R M O N T 0 5 4 0 3
©2020 DR Power Equipment. All rights reserved
A0001141151_A