DR Power Equipment PTO POST HOLE DIGGER Sicherheits- und Betriebsanleitung - Seite 11

Blättern Sie online oder laden Sie pdf Sicherheits- und Betriebsanleitung für Werkzeuge DR Power Equipment PTO POST HOLE DIGGER herunter. DR Power Equipment PTO POST HOLE DIGGER 16 Seiten.

Chapter 4: Maintaining The DR PTO Post Hole Digger

Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this manual for
maintenance procedures.
Disengage PTO, shut down the Tractor Engine, remove the Key, wait for all moving parts to come to a complete stop, lower the
Auger to the ground, disconnect the PTO shaft from the Tractor, then wait five minutes for parts to cool before performing any
maintenance procedure or inspection on the Post Hole Digger.
Regular Maintenance Checklist
Disengage PTO, shut down the Tractor Engine, remove the Key, wait for all moving parts to come to a complete stop, disconnect
the PTO shaft from the Tractor, then wait five minutes before performing any maintenance procedure or inspection on the Mower.
Note: Consider that the service intervals shown are the maximum under normal operating conditions. Increase frequencies under
extremely dirty or dusty conditions. See the Owners Manual that came with the Tractor and with the PTO Shaft for Specific
Tractor and PTO Shaft maintenance.
P
ROCEDURE
Check General Equipment Condition, e.g. Nuts, Bolts,
Welds, etc.
Clean all Debris from the machine.
Check the Auger point and Cutting Edges for
excessive dullness or damage.
Replace broken or damaged Auger point and Cutting
Edges.
Lubricate PTO Shaft Spline ends and center overlap
Check Gearbox Oil
Greasing the PTO U-Joints
Your PTO Shaft was greased at the Factory so it will not need grease until the
scheduled maintenance as listed at the beginning of this Chapter.
Tools and Supplies needed:
Flexible hose grease gun
Lithium grease
Clean cloth
Note: The U-Joint Grease Fitting is sometimes located on the inside of the Joint.
The plastic Collar will need to be unclipped and pushed down to access the
Fitting for this type.
1. Wipe all dirt, etc., from the PTO Shaft grease fittings with a clean cloth.
2. Apply no more than three pumps of quality general-purpose lithium grease
with a hand-pumped grease gun to each of the two U-Joint Grease Fittings
(Figure 14).
B
E
18-
E
EFORE
VERY
E
U
20 H
H
ACH
SE
OURS
Figure 14
Figure 38
CONTACT US AT www.DRpower.com
50
VERY
OURS
U-Joint
Grease Fitting
U-Joint
Grease Fitting
11