AMS Controls MP328CL Referenzhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Referenzhandbuch für Controller AMS Controls MP328CL herunter. AMS Controls MP328CL 17 Seiten. Closed loop backgauge controller

Seite drucken

AMS Controls

5/23/2012

Ref. Pos.

The REFERENCE POSITION is the distance from the reference

point to the inside jaws of the gripper after being referenced.

Lip Size

If this parameter is greater than zero, a lip will be added to the

beginning of each sheet. The acceptable range of values are

0.0000" to 50.0000".

Metal Flow

This parameter specifies whether the metal is fed from one side

of the brake and the formed parts comes out of the other

(NORMAL); or if it is fed through the backside of the brake,

(REVERSE). If this parameter is set to NORMAL, the machine

should move to the total sheet length plus the CLEARANCE

DISTANCE when there is a new program. When REVERSE is

selected, it will move to the new CLEARANCE DISTANCE.

Clearance Dist

This parameter determines the point at which the gripper will

move to when a new program is entered or after completion of a

sequence. CLEARANCE DIST plus ACTUAL PART LENGTH

will determine the position of the guide between sequences.

Brake Dwell Dn

BRAKE DWELL DOWN is the time it takes for the brake to move

from the top of the stroke to the bottom of the stroke. The range

of time allowed is 0.001 to 9.999 seconds and can be set to the

nearest millisecond.

Brake Dwell Up

BRAKE DWELL UP is the time necessary for the brake to return

from the bottom to the top of its stroke

NOTE:

If the LOOP ENABLE input is used while the brake is

activated, the LOOP ENABLE input must be reactivated

before the total BRAKE DWELL (down and up) is completed.

MP328CL Controller

Gripper