AMSEC BSL-0601A-W Betriebs- und Installationsanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Betriebs- und Installationsanleitung für Schlösser AMSEC BSL-0601A-W herunter. AMSEC BSL-0601A-W 20 Seiten. Biometric safe lock

Seite drucken

American Security Products Co

AMSEC Biometric Safe Lock Operating Instructions

ATTENTION:

• For indoor use only.

• Use one 9V alkaline battery. Manufacturer recommends to use Duracell™ or

Energizer® Alkaline batteries. Always use an alkaline battery for high quality

performance, otherwise controller might not work well.

• Battery Low Voltage: 5.4 ± 0.2V. The display will alert low battery when battery voltage

reaches 5.4±0.2V. PLEASE REPLACE THE BATTERY IMMEDIATELY.

Note: The voltage is checked during each time the entry pad is verifying fingerprints. In

the case of low battery, when the LCD screen light is off, i.e. the entry pad is not working;

the battery voltage will be a little higher than 5.4±0.2V. In this case, the battery does not

have enough power for operations other than fingerprint verification to unlock.

• When the display alerts low battery, the Biometric Entry Pad can only be operated to lock

or unlock. Operations, such as enrolling, deleting or time-delay setting, are not permitted.

Security level classification

Level 1: Entry pad can be operated by a code. (Factory Default)

Level 2: Entry pad must be operated by a fingerprint and its bound code. It is a higher

security level. Factory default security level is Level 2.

Level 3: Entry pad must be operated by a fingerprint or a code.

Note: Security Level 3 is a "Non-U.L. Certificated Operating Mode".

For safety and security, all codes will be automatically deleted when security level is

changed. ID No. 01 code will be default code 1234567890.

Battery Replacement Instructions

In the back of Entry Pad you will see one 9 V alkaline battery. Take the battery out of the

battery compartment. Gently pull on the battery until it drops out.

Gently remove the connector by unsnapping it from the two terminals on the top of the

battery.

Never Pull on the Battery Leads.

Connect a new 9 V alkaline battery to the battery clip.

Put the battery and the leads completely back into the battery compartment.

For mounting and wiring information refer to the installation instructions in this manual.

02/10

Part #4305278