Electrolux # Handbuch für Gebrauch und Pflege - Seite 18

Solutions to Common Problems

SURFACE BURNERS DO NOT UGHT

[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []

Surface Control knob has not been completely turned to LITE. Push in and turn the

Surface Control knob to LITE until burner ignites and then turn control knob to desired

flame size.

Be sure gas supply valve is open.

Burner ports are clogged. Clean burners. See Cleaning

the Burner Grates, Burner

Caps,Burner

Heads in General Care & Cleaning section. With the burner off, clean

ports with a small-gauge wire or needle.

Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord is

securely plugged into the outlet.

Electrical power outage (electric ignition models only). Burners can be lit manually. See

Setting Surface Controls

in this Use and Care Guide.

BURNER FLAME ONLY LIGHTSHALF WAY AROUND

BURNER

[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []

Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire

or needle.

Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until

flame is full. Dry the burners thoroughly following instructions in the General Cleaning

section.

BURNERFLAMEIS ORANGE

[]

•

Dust particles in main line. Allow the burner to operate a few minutes until flame turns

blue.

•

In coastal areas, a slightly orange flame is unavoidable due to salt air.

[]