Bosch 300 Series Service-Handbuch - Seite 13

Blättern Sie online oder laden Sie pdf Service-Handbuch für Geschirrspüler Bosch 300 Series herunter. Bosch 300 Series 36 Seiten. Built-in wall ovens
Auch für Bosch 300 Series: Gebrauchsanweisung Handbuch (40 seiten), Benutzerhandbuch (21 seiten), Installationshandbuch (6 seiten), Installationshandbuch (36 seiten), Installationshandbuch (32 seiten), Gebrauchs- und Pflegeanleitung / Installationsanleitung (40 seiten), Betriebsanleitung (50 seiten), Schnellstart- und Sicherheitshandbuch (7 seiten), Installationshandbuch (28 seiten), Schnellstart-Handbuch (7 seiten), Handbuch für Gebrauch und Pflege (32 seiten), Schnellstart- und Sicherheitshandbuch (7 seiten), Schnellstart- und Sicherheitshandbuch (13 seiten)

Bosch 300 Series Service-Handbuch
1. Press and hold Info for two seconds to access the Setup
menu.
2. Press the arrows
Temperature Offset.
3. Rotate the Settings dial to set the desired value.
4. Press the arrows
which will confirm the offset entry.
5. Press Info to exit the Setup menu.
Note: for double ovens, an offset can be entered separately for each
oven by selecting either Up. Offset or Lo. Offset from the menu.
4.6.1.3 HBL8x50
The oven must be Off in order to access the menu.
1. Press and hold Info for two seconds to access the Setup
menu.
2. Press the arrows
Temperature Offset.
3. Press + and – to set the desired value.
4. Press the arrows
which will confirm the offset entry.
5. Press Info to exit the Setup menu.
Note: for double ovens, an offset can be entered separately for each
oven by selecting either Up. Offset or Lo. Offset from the menu.
4.7

Broil Element

All Bosch models have a recessed 10-pass (240V 3600W) broil
element.
Refer to the Element Strip Diagram to test the element at the control
module, or
1. Remove the 2 T20 screws securing the element to the broil
reflector.
to advance through the menu to Oven
to advance to the next menu item,
to advance through the menu to Oven
to advance to the next menu item,
2. Remove the 2 T20 screws on either side of the element
terminals.
3. Pull the element toward you so that the terminal wires are
inside the oven cavity.
4. Disconnect the wires from the inner broil element terminals.
5. Use an ohmmeter to check for resistance of ~16 ohms.
4.8

User Interface

Figure 12 reflects the variations of the B1, B2, and B3 user interfaces
used in the Bosch ovens.
Service Manual for Bosch Built-in Wall Ovens
Page 13 of 36