Bosch DISHWASHER Installationsanleitung Handbuch - Seite 9

Seite drucken

Bosch DISHWASHER Installationsanleitung Handbuch

Y-branch

Tailpiece

Figure 7

Remove

plug

Figure 9

Step 1

Figure 10

Step 1

Figure 11

Plumbing Preparation/ Dishwasher Preparation

PLUMBING PREPARATION (continued)

Air Gap

Drain Plumbing

Under Sink Drain Connection

If the dishwasher is to drain either directly into the

household drain plumbing or through an air gap, install a

y-branch tailpiece under the sink as shown in Figure 7.

Installing an Air Gap

If local ordinances require an air gap, as shown in

Figure 8, install it according to the manufacturer's

instructions.

Disposer

Make sure to remove the disposer's dishwasher drain

Figure 8

connection plug before connecting the dishwasher drain

hose. See Figure 9.

DISHWASHER PREPARATION

Dishwasher preparation involves four tasks:

• Installing the Mounting Brackets

• Removing the Toe Panel

• Installing the 90° elbow fitting

• Junction Box Preparation

Installing the Countertop Mounting Brackets

The dishwasher can be secured into its enclosure in two

ways:

1 Top Mount is used for countertops made of wood or

Step 2

2 Side Mount is used for countertops made of marble,

Step 2

Before installing the supplied countertop mounting

brackets, decide which method of securing the

dishwasher into its enclosure will be used. Once

the mounting brackets are installed on the dish-

washer, removing them is difficult and will damage

the mounting brackets and the dishwasher.

other materials that can easily drilled. Orient the

mounting brackets as shown in Figure 10, and

position the two small tabs on the mounting brackets

over the two slots on the dishwasher's front corners.

Push the mounting brackets down firmly to insert the

tabs into the slots.

granite, or other very hard materials that cannot be

easily drilled. Bend the mounting brackets along the

small holes and in the same direction as the two small

tabs. Orient the mounting brackets as shown in Figure

11, and position the two small tabs on the mounting

brackets over the two slots on the dishwasher's front

corners. Push the mounting brackets down firmly to

insert the tabs into the slots.

WARNING

Tip Over Hazard

To avoid a tip over hazard, do not use the

dishwasher until it is completely installed. When

opening the door on an uninstalled dishwasher,

carefully open the door while supporting the rear

of the unit. Failure to follow this warning can

result in serious injury.