Bosch FAP-OC 500Series Installationshandbuch - Seite 3

Seite drucken

Bosch FAP-OC 500Series Installationshandbuch

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE

F E

S A

A N

R T

P O

A D

I M

R E

APPLIANCE AFTER INSTALLATION IS COMPLETE.

IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE

LOCAL ELECTRICAL INSPECTOR'S USE.

WARNING

If the information in this manual is not followed exactly,

fire or shock may result causing property damage or

personal injury.

WARNING

Do not repair, replace or remove any part of the

appliance unless specifically recommended in the

manuals. Improper installation, service or maintenance

can cause injury or property damage. Refer to this

manual for guidance. All other servicing should be done

by an authorized servicer.

Appliance Handling Safety

Unit is heavy and requires at least two people or proper

equipment to move.

Do not lift appliance by door handle.

Hidden surfaces may have sharp edges. Use caution

when reaching behind or under appliance.

Safety Codes and Standards

This appliance complies with the latest version of one or

more of the following standards:

CAN/CSA C22.2 No. 61 - Household Cooking Ranges

▯

UL 858 - Household Electric Ranges

▯

CAN/CSA C22.2 No. 150 - Microwave Ovens

▯

UL 923 - Microwave Cooking Appliances

▯

UL 507 - Electric Fans

▯

CAN/CSA C22.2 No. 113 - Fans and Ventilators

▯

CSA C22.2 No. 64 - Household Cooking and Liquid-

▯

Heating Appliances

UL 1026 - Electric Household Cooking and Food

▯

Serving Appliances

It is the responsibility of the owner and the installer to

determine if additional requirements and/or standards

apply to specific installations.

A N

Electric Safety

V E

S A

WARNING

Before you plug in an electrical cord or turn on power

supply, make sure all controls are in the OFF position.

For appliances equipped with a cord and plug, do not

cut or remove the ground prong. It must be plugged into

a matching grounding type receptacle to avoid electrical

shock. If there is any doubt as to whether the wall

receptacle is properly grounded, the customer should

have it checked by a qualified electrician.

If required by the National Electrical Code (or Canadian

Electrical Code), this appliance must be installed on a

separate branch circuit.

Installer – show the owner the location of the circuit

breaker or fuse. Mark it for easy reference.

Before installing, turn power OFF at the service panel.

Lock service panel to prevent power from being turned

ON accidentally.

Be sure your appliance is properly installed and

grounded by a qualified technician. Installation, electrical

connections and grounding must comply with all

applicable codes.

Microwave Safety

PRECAUTIONS TO BE OBSERVED BEFORE AND

DURING SERVICING TO AVOID POSSIBLE EXPOSURE

TO EXCESSIVE MICROWAVE ENERGY

Do not operate or allow the oven to be operated with

▯

the door open.

Make the following safety checks on all ovens to be

▯

serviced before activating the magnetron or other

microwave source, and make repairs as necessary:

Interlock operation

Proper door closing

Seal and sealing surfaces (arcing, wear, and other

damage)

Damage to or loosening of hinges and latches

Evidence of dropping or abuse

Before turning on microwave power for any service

▯

test or inspection within the microwave generating

compartments, check the magnetron, wave guide or

transmission line, and cavity for proper alignment,

integrity, and connection.

Any damaged or misadjusted components in the

▯

interlock, monitor, door seal, and microwave

generation and transmission systems shall be

repaired, replaced, or adjusted by procedures

described in this manual before the oven is released

to the owner.

A microwave leakage check to verify compliance with

▯

the Federal Performance Standard should be

performed on each oven prior to release to the owner.

E S

T H

N S

I O

C T

R U

S T

I N