Bosch HV68T53UC Series Betriebsanleitung - Seite 22
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Geschirrspüler Bosch HV68T53UC Series herunter. Bosch HV68T53UC Series 27 Seiten. 500 series built-in dishwasher
Seite drucken
Troubleshooting Guide
Dishwashers may occasionally exhibit problems that are unrelated to a mal-
function of the dishwasher itself. The following information may help you
with a dishwasher problem without involving a repair professional.
Problem
1. Door may not be properly
latched
2. Unit may not be turned on
3. Unit not reset or previous cycle
Dishwasher
not completed
does not
4. Delay start engaged
start
5. Interruption of electrical power
supply to dishwasher or blown fuse.
6. The door may have been closed
without first selecting a cycle
7. Water supply may not be turned on
Display
1. A fuse may have been blown or
does not
circuit breaker tripped
illuminate
2. Door not closed or latched
Note: For models with controls on
top of the door, the display only illu-
minate when the door is opened and
controls are visible.
Dishwasher
1. Incoming water is not warm
seems to
enough
run a long
2. Cycle time can vary due to soil
time
and water conditions
3. Rinse aid dispenser is empty
4. Dishwasher connected to cold
water supply
Note: Refer to "Wash Cycle Informa-
tion" section in this manual for typi-
cal cycle lengths.
Dishes are
1. Spray arm movement obstructed
not getting
2. Spray arm nozzles clogged
clean
3. Improper use of detergents
enough
4. Filters could be clogged
5. Dishes are nested or loaded too
close together
6. Selected wash cycle is not suitable
for food soil conditions
21
Cause
Action
1. Shut the door completely until you
hear a click
2. Press the main power switch to
turn unit on
3. To reset, refer to "Cancel a Cycle"
section in this manual
4. To reset, refer to "Delay Start"
section in this manual
5. Check circuit breaker
6. Select a cycle and close the door.
7. Check and turn on water supply
1. Check the fuse or circuit breaker
box and replace the fuse or reset the
breaker if necessary
2. Ensure door is properly latched
and completely closed
1. Before starting a cycle, run hot
water faucet at the sink closest to
the dishwasher
2. Sensors in the dishwasher auto-
matically increase the cycle time to
ensure a good wash when heavy soil
is detected
3. Add rinse aid
4. Verify dishwasher is connected to
hot water supply plumbing
1. Ensure that spray arm movement is
not blocked by hand rotating spray arms
before starting cycle
2. Remove the spray arms and clean
according to the "Care and Mainte-
nance" section of the manual
3. Increase or decrease detergent
depending on the water hardness
4. Clean the filters according to the "Care
and Maintenance" section of the manual
5. Rearrange load such that water
spray can reach all items in the dish-
washer - see "Loading the Dishwasher"
section of the manual
6. Refer to "Wash Cycle Information" sec-
tion of the manual