Dragon-RC Speedo DX-10 WP45 Gebrauchsanweisung - Seite 3

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Controller Dragon-RC Speedo DX-10 WP45 herunter. Dragon-RC Speedo DX-10 WP45 8 Seiten.

Sensored Mode

When using a Sensored Brushless motor, the Blue motor wire A, Yellow motor wire B

and Orange motor wire C of the ESC must be connected with the Sensored motor wire

A,B,C accordingly. It is necessary to connect the Sensor wire to the 'Sensor' socket on

the ESC. Don't change the wires sequence optionally.

Sensorless Mode

When using a Sensoreless Brushless motor, the Blue motor wire A, Yellow motor wire B

and Orange motor wire C of the ESC can be connected with the motor wires freely.

If the motor runs in the opposite direction, please swap any two wire

connections.

Connection to the Receiver

Black wire RX-

Red wire

RX+6.0V

White wire RX-Signal

LEDs:

Conversion of Sensored and Sensorless Function

l When the Power wires on the ESC are connected with the battery pack, the ESC

can automatically identify the motor type (Sensored/Sensorless) via indicated LEDs.

l If the ESC works at the status of Sensored, remove the Sensor wire,

the ESC can be automatically changed to the status of Sensorless.

Function

Low voltage of the battery

Over-heat of the ESC and motor (95)

Sensored motor

Sensorless motor

Throttle Range Calibration

1. Turn on the transmitter, then connect ESC with the battery packs and set the direction

of the throttle channel to REV; set the EPA/ATV value of the throttle channel to 100%.

2. Press and hold the 'Set' button and switch on the ESC, release the button when

the orange LED turn solid. Pull the throttle trigger to full position, red Led light will

flash, Led will turn solid and motor beeps once. when system confirms the position.

3. Push the throttle trigger to full Brake position, red Led light will flash, Led will turn

solid and motor beeps twice when system confirms the position.

4. Now trigger goes back to neutral position, both of the Red Led and Orange Led

blink, Led lights will turn solid and motor beeps three times when system confirms

the position.

5. Turn off the ESC power switch to save the settings.

6. Turn the ESC back on. You are ready to use the ESC now.

LED

Red LED

Orange LED

Red and Orange LED

Orange LED

LED Status

Blinking