Advanced Elements AdvancedFrame AE1012 Benutzerhandbuch - Seite 14
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Boot Advanced Elements AdvancedFrame AE1012 herunter. Advanced Elements AdvancedFrame AE1012 20 Seiten. 1 person kayak
Auch für Advanced Elements AdvancedFrame AE1012: Benutzerhandbuch (20 seiten), Benutzerhandbuch (19 seiten)
Seite drucken
TM
6.2 Repairing Pinholes
1. Inflate the PVC tube. Locate the pinhole by sponging soapy water over the tube until
you see air bubbles. Mark the location of the pinhole.
2. Deflate the tube and dry the affected area. Apply a drop of glue to the pinhole
3. Allow glue to dry completely.
4. Do not inflate the kayak for at least twelve hours.
7. TROUBLESHOOTING
PROBLEM
Does not hold air
while inflating.
The kayak is sagging
or under inflated.
The kayak will not hold
full pressure for more
than a couple of hours.
Kayak still loses air.
Tube is kinked or
bent in.
The fin is bent.
The floor has formed
a large bubble.
14
SOLUTION
The spring valve uses a plunger system. The only time the plunger
should be in the open position is when you are deflating. Make sure
that the plunger is closed to inflate. Push the plunger in and rotate
counter-clockwise.
Be sure that the right pump is being used. You need a bellows foot
pump or a double action hand pump. A 12-V electric does not supply
enough pressure to fully inflate the kayak. The 12-V can be used to par-
tially inflate the kayak but one of the other pumps is needed to top it off.
Make sure that the plunger is in the closed position. It should only
be open when deflating. If it is open, the only seal is the black rubber
gasket inside the cap. Even then, a little air may still leak out.
If you have checked all the previous possible reasons for the kayak
losing air, then there may be a pinhole or a puncture somewhere on the
tube. Pull tube from outer covers. Inflate. If you cannot see or hear
where a leak may be, take a clean rag with soapy water and begin rub-
bing the tube. If a hole is present, bubbles will continually form. Repair
using repair kit. If it is a very small pinhole, a dab of the glue may be
sufficient.
The tube just needs to be adjusted. When kayak is fully deflated try ad-
justing the position of the tube inside of the outer shell. Then reinflate.
After inflating the kayak, turn upside down and leave out in sun for ap-
proximately ten minutes. Fin will conform to its original shape. Even if
it is slightly bent, it will not affect the kayaks performance.
If two of the ridges in the floor have formed one large one, the I-beam
has come apart. This is caused by over inflation. It cannot be repaired.
It is important to take all over inflation warnings very seriously.