DragonTouch Vision 3 Pro Benutzerhandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Action-Kameras DragonTouch Vision 3 Pro herunter. DragonTouch Vision 3 Pro 14 Seiten.

Do not make any unauthorized alterations to the camera. Doing so may compromise

safety, regulatory compliance, performance, and may void the warranty.

WARNING:

Do not drop, disassemble, open, crush, bend, deform, puncture, shred,

microwave, incinerate or paint the camera or battery. Do not insert foreign objects into

the battery opening on the camera. Do not use the camera or the battery if it has been

damaged—for example, if cracked, punctured or harmed by water. Disassembling or

puncturing the battery can cause an explosion or fire.

REMOTE

VIDEO

To record Video, verify the camera is in Video mode.

To start recording:

Press the Grey Video Button. The camera will emit one beep and the camera light will

flash while recording.

To stop recording:

Press the Grey Video Button again. The camera will emit one beep and the camera light

will stop flashing while recording.

PHOTO

To capture a photo, verify the camera is in Photo mode.

To take a photo:

Press the Red Photo Button. The camera will emit a camera shutter sound.

Photo Button

Video Button

Splashproof only, not waterproof

CR2032 BATTERY REPLACEMENT FOR VISION 3 PRO REMOTE

1. Use a 1.8mm Phillips tip screwdriver to remove the 4 screws on the back cover of the

remote, allowing you to open it.

2. Remove another 4 screws on PCB board.

3. Lift the PCB board and slide out the battery, as shown in the picture.

Note: Do NOT rotate the PCB board to avoid reversing the camera and video button functions.

4. Install the new battery, keeping the "+" pole facing up.