Electrolux # Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Backofen Electrolux # herunter. Electrolux # 16 Seiten. Gas cooktop
Auch für Electrolux #: Installationsanleitung Handbuch (8 seiten), Handbuch für Gebrauch und Pflege (20 seiten), Rezeptbuch (17 seiten), Gebrauchsanweisung (12 seiten), Handbuch für Gebrauch und Pflege (20 seiten), Gebrauchsanweisung (16 seiten), Gebrauchsanweisung (12 seiten), Insrtuktionshandbuch (16 seiten), Benutzerhandbuch (11 seiten), Benutzerhandbuch (9 seiten), Handbuch für Gebrauch und Pflege (16 seiten), Handbuch für Gebrauch und Pflege (16 seiten), Handbuch für Gebrauch und Pflege (16 seiten)

Seite drucken

General installation

Connect the exhaust duct to the outside exhaust system (see

pages 4 through 6). Use of a 4" (10.2 cm) clamp (item A) is

recommended to connect the dryer to the exhaust vent system.

Use metal foil tape to seal all other joints.

Carefully slide the dryer to its ﬁ nal position. Adjust one or more of

the legs until the dryer is resting solidly on all four legs. Place a level

on top of the dryer. The dryer MUST be level and resting solidly on

all four legs. Rock alternating corners to check for stability. Remove

and discard door tape.

Be sure the power is off at a circuit breaker/

fuse box before plugging the power cord into an outlet.

Plug the power cord into a grounded outlet.

Turn on the power at the circuit breaker/fuse box.

Read the

Use & Care Guide provided with the dryer. It contains

valuable and helpful information that will save you time and

money.

If you have any questions during initial operation, please review

the "Avoid Service Checklist" in your Use & Care Guide before

calling for service.

Place these instructions in a location near the dryer for future

reference.

A wiring diagram and technical data sheet are

located inside the dryer console.

Door Reversal

Your dryer is designed so the door swing may be reversed at

any time without additional parts. Conversion is accomplished

by transferring hinges to the opposite side of the cabinet.

To change the direction of the door opening:

Open the dryer door. Remove the four hinge hole plugs from

the left side of the door opening. Place nearby for future

installation.

You may need a plastic knife to help pull out the

plugs. Be careful not to scratch the paint.

Remove the four screws that secure the door hinges to the

dryer front panel (see right).

Rotate the door 180° and reinstall the door hinges to the

dryer front panel with the four screws.

Install the four hinge hole plugs in the open screw holes on

the opposite side of the door opening.

Replacement parts:

If replacements parts are needed for your dryer, contact the

source where you purchased your dryer.

- ELECTRICAL SHOCK HAZARD - Label all

wires prior to disconnection when servicing controls. Wiring

errors can cause improper and dangerous operation. Verify

proper operation after servicing.