Advanced Elements StraitEdge2 AE1014 Benutzerhandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Boot Advanced Elements StraitEdge2 AE1014 herunter. Advanced Elements StraitEdge2 AE1014 20 Seiten. Straitedge2 inflatable kayak
Seite drucken
3.3 Inflating
IMPORTANT: Before inflating, check to be sure that the kayak is completely assembled.
Inflate your kayak in the following order. Failure to follow these instructions may cause
damage to your kayak. Do not over inflate.
1. Locate chamber 1. Unscrew cap and check that plunger valve is in the inflate position.
Inflate Chamber 1 until firm to the touch (2.25 psi ONLY).
2. Proceed to chamber 2. Inflate chamber 2 until StraitEdge™ tube is firm to touch (2.25 psi
ONLY). Close caps on chambers 1 and 2 tightly.
3. Locate chambers 3 and 4 "floor." Make sure valve body is screwed in tightly. Remove small
cap (See Figure 2) and use appropriate pump nozzle. Inflate chambers until firm (1.0 psi
ONLY). Do not over inflate!
4. Locate Chambers 5 and 6. Inflate Chambers 5 and 6 until firm (1.0 psi ONLY).
5. Make sure all valves are closed tightly and properly. Check to be sure the cap tether is
not interfering with the valve seating chambers 3 and 4.
3.4 Over Inflation
CAUTION: Water temperature and weather will affect the air pressure of the kayak. In cold
weather and water your kayak will lose some pressure. If this occurs, you may want to add a
bit more air to the kayak to improve performance. In hot weather or prolonged sunlight, the air
inside the kayak will expand. You must let some air out of the appropriate chambers to prevent
the kayak from failing due to overpressure. You should avoid exposing your kayak to extreme
temperatures (hot or cold).
Diagram of Inflation Chambers
StraitEdge2™ Inflatable Kayak Owner's Manual