Drainvac ProXtrak DV2P56 Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Water Pump Drainvac ProXtrak DV2P56 herunter. Drainvac ProXtrak DV2P56 12 Seiten. Liquid extractor proxtrak series
Seite druckenOPERATING THE MEMBRANE
As illustrated on pages 6 and 7 of this manual, the Automatik system evacuates
wastewater automatically after approximately 10 to 15 minutes. Keep in mind that as
long as the system is operating, water keeps flowing and the unit eventually fills up.
The membrane allows you to adjust the time lapse during which the unit deactivates
and empty its contents. The unit also clears out the wastewater once the unit stops.
WHY CHANGE THIS PARAMETER?
•
With the decanter configuration, the unit can reactivate as soon as there is no
wastewater left to flow through the rubber hand (in other words when all the
wastewater is in the separate funnel).
•
If the unit's drain is located very close to the pipe leading to the sewer and that
there is less restriction to the amount of wastewater that can be evacuated, the
evacuation time could be set on medium.
•
On the other hand, if the diameter of the pipe leading to the sewer is smaller and
restrains the amount of water that can be evacuated, increasing the evacuation
time to a long flushing time could be necessary.
1
2
ON/OFF
MAINTENANCE
FLUSHING TIME
TEMPS DE VIDANGE
MODE/TIMER
1. Hold 6 sec. to reset.
1. Tenir 6 sec. pour réinitialiser.
2. Hit once for short flushing time.
2. Pesez 1 fois pour vidange court.
Hit twice for medium flushing time.
Pesez 2 fois pour vidange moyen.
Hit 3 times for long flushing time.
Pesez 3 fois pour vidange long.
FLUSHING TIME
•
Press once to initiate short flushing time - LED will flash once.
•
Press twice to initiate medium flushing time - LED will flash twice.
•
Press three times to initiate long flushing time - LED will flash three times.
10
ON/OFF
The first LED will stay lit if the unit is on. Press
once to turn it off. It will then start flashing,
indicating that power is still running through the
system, even though the unit is turned off.
MAINTENANCE
The middle LED will light up after 500 hours of
usage. This means maintenance is required and
the unit should be taken to a Drainvac retailer to
be examined. Maintenance should only be reset
by a qualified Drainvac technician.
WHERE TO INSTALL THE UNIT
The liquid extractor is designed to work at a far distance without
having to travel back to the unit to empty the soiled liquids.
This unit cleans up liquids and empties itself automatically.
Essentially, the unit needs to be located over a suitable dumping
point into which liquids can be drained. The most common dumping
points are ; toilet bowls, showers, floor drain or anywhere outside
(where permitted).
Find the most central dumping point related to the entire scope
of the job to set up the unit. If the job is on multiple levels find the
lowest dumping point available.
Open a window in the room
where the unit is located to ex-
haust excess humidity. If located
in a bathroom, start ceiling fan.
TRUCK MOUNT
Cleaning enterprises are currently using portable tanks by "truck mount" to empty the
wastewater elsewhere. Municipalities are increasingly disallowing it!
The ProXtrak DV2P552 / DF2P552 allows to recover the liquids and to empty the waste
directly on site in the sanitary sewers via the toilet. It is the ideal model for sinister
cleaning enterprises which already own a truck mount because these models do not
include any motor!
UNIT INSTALLATION
11