Drake Systems DTH-3002R Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Autoalarm Drake Systems DTH-3002R herunter. Drake Systems DTH-3002R 10 Seiten.

This wire would be connected to the vehicle's positive battery terminal

or a constant positive +12V power supply.

2). BROWN : BROWN wire would be connected with the (+) wire of siren.

And black wire of siren should be connected to ground.

For corrosion resistance, the black wire of siren would be connected inside

the vehicle under the dash board.

3). WHITE : WHITE wire is positive output from on-board relay for light flashing.

This white wire can be connected to the vehicle's parking light wire

at the headlight switch.

Also this wire can be connected directly to any parking light fixture.

4). RED/WHITE ( WHITE STRIP ON RED ) : RED/WHITE wire is connected to the

external relay ( or relay in the vehicle ) for trunk open.

5). GRAY : GRAY wire is connected to the dome light (-).

6). BLACK : BLACK wire is connected to the battery's negative terminal

or to the good chassis ground of the vehicle.

7). BLUE/WHITE (WHITE STRIP ON BLUE): BLUE/WHITE wire is connected to the

(-) UNLOCK or (+) LOCK output.

8). GREEN/WHITE (WHITE STRIP ON GREEN): GREEN/WHITE wire is connected to

the (-) LOCK or (+) UNLOCK output.

9). ORANGE: ORANGE wire is a negative (-) 500mA output when the alarm system is

in the armed mode (ground when armed).

This output can be used with a pre-wired socket for starter kill.

(Relay not included)

10).GREEN: GREEN wire is a negative(-) input for door-pin trigger.

The best place to find the door trigger is either at the pin switch or

at the dome light.

11). VIOLET: VIOLET wire is a positive(+) input for door-pin trigger.

12). YELLOW: YELLOW wire is connected to the "ACC" of key box.

13). PIN CONNECTOR

Shock sensor is connected to the 3pin connector located in the

main controller.

The connector pin description is +12V OUTPUT / TRIGGER INPUT / GND

( from left to right of the connector ).

14). 8PIN CONNECTOR

The base communication module is connected to the 8pin connector.

The DIP switch is located on the upper side of main controller.

If the switches are located downward, it is ON state.

Upward means OFF. The right switch is for passive arm.

If the right switch in ON, this means passive arm is activated.

The passive arm is deactivated when it is turned off (located upward).