Dramm Autofog MLVH-10A Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Farbspritzgerät Dramm Autofog MLVH-10A herunter. Dramm Autofog MLVH-10A 20 Seiten.

Seite drucken

List of tools needed:

• 7/16" Wrench

• 1/2" Open End Wrench

• 9/16" Open End Wrench

• Straight Blade Screwdriver

• MLVH-10A Assembly Diagram

• 1/2" Socket Wrench

1. Attach handle to side of machine opposite control

panel using four 1/4- 20 x 3/4 hex bolts. Tighten.

2. Place lower nozzle stand over studs showing through

red compressor unit cover. Adjusting knob should face

control panel. Place lockwashers and nuts on studs and

tighten.

3. Insert the nozzle stand into the nozzle stand tube with

the nozzle bracket facing away from the control panel

end. Adjust the height of the nozzle stand as necessary.

Tighten the black height adjustment knob.

4. Place the solution tank into the circular tank holder.

Rotate the tank so that the small suction hole faces the

front of the machine (the control panel end is the back

of the machine).

Autofog MLVH-10A Assembly Instructions

5. Secure the nozzle onto the nozzle stand. Insert the

suction tube into the solution tank. Check that the

suction tube reaches the bottom of the tank (there is a

slight depression in the bottom of the tank where the

suction tube should rest). Place the agitator back into

the solution tank and secure with the turn tabs.

6. On the control panel, insert air hose into the press-fit

connection marked AIR TO NOZZLE. On the nozzle,

insert air hose the same way.\

7. Plug the agitator power cord into the control panel and

connect the main power cord into a 110 volt power

source.

8. The unit is ready to spray. But before you start

spraying, read this manual thoroughly and follow all

E.P.A. Guidelines.

9. Before you spray for the first time, test the MLVH-10A

with water. Pour a small amount of clear water (about

1 liter) into the solution tank. Rotate the timer

clockwise. Spraying begins immediately. Observe the

quality of the spray pattern and pressure gauge

readings. If you have any questions, contact the Dramm

Corporation Service Department at 800-258-0848 or

920-684-0227.

Suction Tube

Checkmark

Securing Nut

Dramm Autofog MLVH-10A Manual

Nozzle Cap

Checkmark