Dramm Rain Pro Expandable Installations- und Programmierhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Installations- und Programmierhandbuch für Controller Dramm Rain Pro Expandable herunter. Dramm Rain Pro Expandable 20 Seiten. Expandable controller 3, 7, 11, 15 stations
Seite drucken1. Insert additional module(s) in the terminal strip
area of the controller as needed. Slide each
module from right to left. Firmly slide module in
until it clicks into place. Each module will add 4
stations of additional capacity to the controller.
Install modules in sequence from bottom to top
leaving no gaps.
9V DC BATTERY REMOTE PROGRAMMING
Installing a 9V DC battery on the back of the controller face
plate will allow the controller faceplate to be removed from
housing and can be programmed without being attached to
the controller or any AC power source. The AC power
source is required before any valve activation will
commence. The 9V DC battery is necessary to keep the
"Current Date/Time" active. Without the 9V DC battery,
power loss will lose "Current Date/Time" and "Current
Date/Time" will have to be reset upon power resumption.
A rain sensor or any type of normally closed micro-
switch sensor may be used in conjunction with this
controller. Sensor activation will interrupt controller
output to valves.
1. Route two wires from the sensor through the
bottom of the controller and connect one each
to the two "SEN" terminals. Remove the jumper
wire between these terminals if one exists.
WITHOUT AC POWER
SENSOR WIRING
6