Bosch 6 Series Handbuch für Installation und Gebrauch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Waschmaschine Bosch 6 Series herunter. Bosch 6 Series 20 Seiten. 2 door top freezer, inox-easyclean
Auch für Bosch 6 Series: Benutzerhandbuch (24 seiten), Handbuch für Installation und Gebrauch (20 seiten), Handbuch für Installation und Gebrauch (20 seiten), Gebrauchsanweisung und Installationsanleitung (48 seiten), Gebrauchsanweisung (16 seiten), Gebrauchsanweisung (48 seiten), Installationsanleitung Handbuch (27 seiten), Gebrauchsanweisung (12 seiten), Installations- und Betriebsanleitung (36 seiten), Gebrauchsanweisung (16 seiten), Handbuch für Installation und Gebrauch (16 seiten), Gebrauchsanweisung Handbuch (29 seiten), Benutzerhandbuch und Installationsanleitung (16 seiten), Informationen zur Verwendung (32 seiten), Kurzreferenz-Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Informationen zur Verwendung (28 seiten), Benutzerhandbuch (23 seiten), Gebrauchsanweisung (24 seiten), Montage- und Gebrauchsanweisungen (24 seiten), Informationen zur Verwendung (16 seiten), Benutzerhandbuch (36 seiten), Benutzerhandbuch (32 seiten), Benutzerhandbuch (28 seiten), Benutzerhandbuch (28 seiten), Gebrauchsanweisung (28 seiten), Informationen zur Verwendung (20 seiten), Gebrauchsanweisung (28 seiten)

Seite drucken

Bosch 6 Series Handbuch für Installation und Gebrauch

Lighting

The lighting can be switched on and off independently

of the fan.

Touch the

symbol.

Setting the brightness

Press and hold the

symbol until the required

brightness is reached.

Saturation display

If the metal grease filters or activated charcoal filter are/

is saturated, the corresponding symbols will flash once

the appliance has been switched off:

Metal grease filter:

■

Activated charcoal filter:

■

Metal grease filter and activated charcoal filter:

■

and

If you have not yet done so, the metal grease filters

should now be cleaned or the activated charcoal filter

replaced. ~ "Cleaning and maintenance" on page 9

The saturation indicators can be reset while they are

flashing. To do this, touch the appropriate symbol.

Switching over the display for air recirculation mode

For air recirculation mode, the electronic controller must

be switched over accordingly:

The extractor hood must be connected and switched

■

off.

Touch and hold the

■

symbol.Take your finger off the

will switch the electronic controller over to air

recirculation mode (filters that cannot be

regenerated).

Touch and hold the

■

symbol.Take your finger off the

will switch the electronic controller over to air

recirculation mode (filters that can be regenerated).

Repeatedly touching and holding the

■

and touching the "1" symbol switches the electronic

controller back over to air extraction mode.

Audible signal

Switching on

Touch and hold the

time for approximately 3 seconds when the fan is

switched off. An audible signal will sound as an

acknowledgement.

Switching off

Touch and hold the

time for approximately 3 seconds when the fan is

switched off. An audible signal will sound as an

acknowledgement.

symbol. Touch the "2"

symbol. This

symbol. Touch the "3"

symbol. This

and

symbols at the same

and

symbols at the same

2Cleaning and maintenance

Warning

C l e a n i n g a n d m a i n t e n a n c e

Risk of burns!

The appliance becomes hot during operation. Allow the

appliance to cool down before cleaning.

Warning

Risk of electric shock!

Penetrating moisture may result in an electric shock.

Clean the appliance using a damp cloth only. Before

cleaning, pull out the mains plug or switch off the circuit

breaker in the fuse box.

Warning

Risk of electric shock!

Do not use any high-pressure cleaners or steam

cleaners, which can result in an electric shock.

Warning

Risk of injury!

Components inside the appliance may have sharp

edges. Wear protective gloves.

Warning

Risk of injury!

Risk of trapping body parts when opening and closing

the glass front. Do not reach into the area behind the

glass panel, and keep your fingers away from the

hinges.

Cleaning agents

To ensure that the different surfaces are not damaged

by using the wrong cleaning product, follow the

instructions in the table. Do not use any of the following:

Harsh or abrasive cleaning agents, e.g. scouring

■

powder or liquid scouring cleaner,

Cleaning products with a high alcohol content,

■

Hard scouring pads or cleaning sponges,

■

Pressure washers or steam cleaners,

symbol

■

Cleaning products that dissolve limescale,

■

Aggressive all-purpose cleaning products,

■

Oven spray.

■

Wash new sponge cloths thoroughly before use.

Note:

Follow all instructions and warnings included with

Note:

the cleaning products.

Cleaning and maintenance en