Exterior Motorized FlexShade
Section 12 - RF Remote Programming Instructions
Please Note: The motor ships with no programming. Follow these instructions to program unit to the desired transmitter.
Pen
Programming
Button
BACK
Setting an Intermediate Stop -
Shade MUST BE in USER mode.
SHADE
1. Move shade to desired mid-point
2. To test, press the MY/STOP button
3. To delete an intermediate stop, go to the
Add a Channel -
Shade MUST BE in USER mode.
Pen
1. Select channel currently operating
2. Select new channel to add to motor, then
Programming
3. The motor should now work on both the
Button
BACK
Delete a Channel -
Shade MUST BE in USER mode.
1. Select channel operating motor desired,
Pen
2. Select channel to remove, then hold
Programming
Button
BACK
1. Select a transmitter channel to assign motor.
2. Check motor direction. To reverse motor
3. Move motor to upper limit position. Hold MY/
UP
STOP
DOWN
4. While motor is at lower limit, hold UP and MY/
LED Lights
Channel
Selector
5. Next, hold MY/STOP button until motor jogs.
6. Put motor into USER MODE by holding small
location and hold MY/STOP button
until motor jogs.
when motor is standing still. The shade
will move to that intermediate location.
intermediate stop and hold the MY/STOP
button until motor jogs.
motor, then hold programming button
until motor jogs.
hold programming button until motor jogs.
old and new channel.
then hold programming button until
motor jogs.
programming button until motor jogs.
Motor should now only work
on channel kept from Step 1.
®
Hold UP and DOWN buttons
until motor jogs, then release.
direction, hold MY/STOP button for
5 seconds until motor jogs. Check direction
again.
STOP and DOWN buttons until motor moves
down, then release. Use UP and DOWN buttons
to move shade to correct lower limit and press
MY/STOP.
STOP buttons until motor moves up, then
release. The shade should move to upper limit
and stop.
programming button on the back of transmitter
and waiting for motor to jog.
SHADE
SHADE
upper
or
lower
limit
Programming
Button
BACK
Adjust Limits in User Mode
1. Move motor to limit
changed. Shade must move to previously
set limit and will stop automatically.
2. Hold UP and DOWN buttons until motor
jogs.
3. Move motor to its new limit location and
hold MY/STOP button until motor jogs.
Reset Motor
Pen
1. Disconnect for 3 seconds, reconnect for
10 seconds, disconnect for 3 seconds.
Shade will roll.
2. Hold program button on remote and wait
for 2 separate jogs.
Motor is now reset.
page 11 of 16
SHADE
SHADE
to be
(upper or lower)
Seite drucken