Draper nocturne+ c Anweisungen für Installation und Betrieb - Seite 2

Blättern Sie online oder laden Sie pdf Anweisungen für Installation und Betrieb für Projektionsfläche Draper nocturne+ c herunter. Draper nocturne+ c 4 Seiten. Outdoor crank-operated projection screen
Auch für Draper nocturne+ c: Anleitung Handbuch (6 seiten), Anleitung Handbuch (10 seiten), Anleitung Installation & Betrieb (8 seiten)

Seite drucken

Nocturne

Section 2 - Mounting Case with Brackets - Wall Installation

Attaching Mounting Brackets

1. Attach mounting brackets to the wall using #10 flat head screws installed flush with bracket.

Be sure to use AT LEAST 2 of the top mounting holes (See Fig. 2).

Attaching Case to Mounting Brackets

1. Attach Case to brackets and tighten Set Screws (See Fig. 3).

2. You are now ready to mount the Side Cables (See Page 3).

Section 3 - Mounting Case - Permanently to Ceiling or Wall

Attaching Mounting Brackets to Case

1. Attach Mounting Brackets to the Case as a spacer between the Case and the wall.

Please Note: Leave a 1¾" (45mm) gap between End Cap and Mounting Bracket (See Fig. 4),

and tighten set screws.

2. Removing Roller Assembly

A. Remove screws from bottom of Case, remove Front cover and set aside.

B. Remove Quick Release Pin from Idler End of Roller Assembly.

C. Remove Roller Assembly, Idler End first, and set aside.

3. Mounting to Ceiling / Wall

Using the mounting holes in the end caps as a guide (See Fig. 6), drill pilot holes on both ends

of the Case. Attach to mounting surface using appropriate fasteners.

Please Note:

It is the responsibility of installer to use appropriate fasteners for the mounting surface.

4. Once the Case is secured to the mounting surface, re-install Roller Assembly*,

Quick Release Pin and Front cover.

5. You are now ready to mount the Side Cables (See Page 3).

page 2 of 4

Figure (2)

Tighten Set Screws

Figure (3)

Leave a

Mounting Bracket

1¾" (45mm)

GAP

as spacer and

Tighten Set Screws

REMOVE

COVER

REMOVE QUICK

REMOVE ROLLER ASSEMBLY

RELEASE PIN

Remove screws from

bottom of Case

CEILING

MOUNT HOLES

WALL

MOUNT HOLES

Figure (4)

Attach

Figure (5)

Figure (6)