Bosch Vision 800 Series Service-Handbuch - Seite 22
Blättern Sie online oder laden Sie pdf Service-Handbuch für Waschmaschine Bosch Vision 800 Series herunter. Bosch Vision 800 Series 43 Seiten. Gas slide-in ranges
Auch für Bosch Vision 800 Series: Gebrauchsanweisung Handbuch (40 seiten), Abmessungen und Spezifikationen (2 seiten), Installationshandbuch (6 seiten), Installationsanleitung Handbuch (28 seiten), Service-Handbuch (36 seiten)
Seite drucken
58300000202443_ARA_EN_C
6.4
Control Panel
The control panel includes...
Front panel assembly: stainless steel skin, white LED touch
panel assembly, and touch control module (TCM)
Sheet metal carrier
Display module, which is mounted to the carrier
The complete front panel assembly is offered as the service
replacement for the stainless skin, touch panel, and/or TCM. These
components are not available separately.
The TCM is an electronic module which monitors, qualifies, and
transmits the inputs from the touch panel to the control module. After
start-up, the control module polls the TCM every 100ms to determine
which, if any, keys are activated. The response to each key press is
controlled by the control module.
A Front Panel Test is available in Service mode. See the Service
Mode section for details.
Figure 24 Control panel for 800 series single oven
Figure 25 Control panel for 800 series double oven
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JANUARY 2018
6.4.1
1. Remove power to the oven.
2. Protect the top of the oven door to prevent damage to the
stainless front panel or door.
3. Remove two screws on the underside of the panel assembly –
one on the right and one on the left – which secure the panel
to the vent trim; it is not necessary to remove the center screw
at this time.
Use care when detaching the front panel. There may be little slack in
the wires connecting the control module to the display board and the
control module to the touch pad, so it may not be possible to fully
rotate the front panel 90°.
4. Carefully swing the bottom of the control panel outward, then
lift to disengage the side flanges of the front panel carrier from
the slots in the side trim.
Figure 26 Detaching the control panel from the side trims
5. Disconnect the ground wire and the communication harness
connectors at the display board and touch pad; set the front
panel on a flat work surface.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Built-in Wall Ovens
Replacing the Front Panel Assembly
NOTICE
Page 22 of 43
800 944-2904